Kenmore 26.2 cu. ft. French Door Refrigerator w/ Fresh Storage Drawer - Stainless Steel Owner's Manual download pdf (Page 14)

Handle Installation and Removal

Parts Included: Refrigerator door handles (2), Refrigerator

drawer handle (1), Freezer drawer handle (1), ¹⁄₈" hex key, spare

setscrew(s)

Install Handles

Refrigerator Doors

NOTE: Handle mounting setscrews are preinstalled inside the

handle.

1. Remove the handles from the packaging inside the

refrigerator, and place them on a soft surface.

2. Open a refrigerator compartment door. On the closed door,

place a handle onto the shoulder screws so that the

setscrews are facing the adjacent door.

3. Firmly push the handle toward the door until the handle

base is flush against the door.

4. While holding the handle, insert the short end of the hex key

into the upper hole and slightly rotate the hex key until it is

engaged in the setscrew.

5. Using a clockwise motion tighten the setscrew just until it

begins to contact the shoulder screw. Do not fully tighten.

6. Repeat steps 4 and 5 to fasten the lower setscrew.

7. Once both setscrews have been partially tightened as

instructed in the previous steps, fully tighten both setscrews.

IMPORTANT: When the screws feel tight, tighten them an

additional quarter-turn. The handle is not properly installed

without this extra tightening.

8. Repeat steps 2 through 7 to install the other handle onto the

adjacent refrigerator door.

Refrigerator and Freezer Drawers

1. With the drawer closed, place the handle onto the shoulder

screws so that the setscrews are facing down toward the

floor.

2. Firmly push the handle toward the drawer until the handle

base is flush against the drawer.

3. Insert the short end of the hex key into the left-hand hole

and slightly rotate the hex key until it is engaged in the

setscrew.

4. Using a left to right motion tighten the setscrew a quarter-

turn at a time just until it begins to contact the shoulder

screw. Do not fully tighten.

5. Repeat steps 11 and 12 to fasten the right-hand setscrew to

the shoulder screw.

6. Once both setscrews have been partially tightened as

instructed in the previous steps, fully tighten both setscrews.

IMPORTANT: When the screws feel tight, tighten them an

additional quarter-turn. The handle is not properly installed

without this extra tightening.

7. Save the hex key and all instructions.

A. Shoulder screws

B. Setscrews inside the handle

A. Shoulder screw

B. Setscrews inside the handle

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 107 108

Comments to this Manuals

No comments

Kenmore 26.2 cu. ft. French Door Refrigerator w/ Fresh Storage Drawer - Stainless Steel Owner's Manual Page 14

Comments to this Manuals

Related products and manuals for Fridges Kenmore 26.2 cu. ft. French Door Refrigerator w/ Fresh Storage Drawer - Stainless Steel