Kenmore 26.2 cu. ft. French Door Refrigerator w/ Fresh Storage Drawer - Stainless Steel Owner's Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 108
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
10
Replace Drawer Front
1. Pull out the drawer glides until they are fully extended.
2. Lower the loosened screws in the top of the drawer front into
the upper notches in the drawer glides.
NOTE: It helps if one person holds the drawer glides steady
while another person aligns the drawer front and inserts the
screws into the notches.
3. Align the holes in the bottom of the drawer front with the
holes in the bottom of the drawer glides and fasten with the
screws removed earlier.
4. Tighten the two top screws.
Reconnect Wiring
1. Align the two ends of the wiring connector and push them
together until you hear a “click” sound and feel the tabs
snap into place on the connector.
2. Gently pull on the wiring connection to ensure the wiring
connection is completely seated. Replace the wiring cover.
NOTE: The wiring connection must be complete for the
drawer temperature control to operate.
3. Replace the interior bin.
Freezer Drawer
Remove Drawer Front
1. Open the freezer drawer to its full extension.
2. Loosen the two top screws that fasten the drawer front to the
drawer glides. The two screws (one on the left-hand side
and one on the right-hand side) are located inside the
drawer front.
3. Lift up on the drawer front to release the plastic studs from
the drawer glide bracket slots.
4. Slide the drawer glides back into the freezer.
Replace Drawer Front
1. Pull out the freezer drawer glides to their full extension.
2. Holding the drawer front by its sides, align the two plastic
studs, located at the bottom, inside the drawer front, with
the drawer glide bracket slots.
NOTE: It helps if one person holds the drawer glides steady
while another person aligns the drawer front and inserts the
studs into the slots.
3. Replace and tighten the two screws at the top of the drawer
front (one on the left-hand side and one on the right-hand
side).
A. Drawer glide bracket slots
A. Drawer front screw
B. Drawer front plastic stud
A
A
B
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 107 108

Comments to this Manuals

No comments