Kenmore 26.2 cu. ft. French Door Refrigerator w/ Fresh Storage Drawer - Stainless Steel Owner's Manual download pdf (Page 22)

Crisper Drawers

To remove and replace the drawers:

1. Grasp the handle at the bottom of the drawer and slide the

drawer straight out to the stop. Lift the drawer off the

bottom guide.

2. Replace the drawer by placing it on the bottom drawer

guide and pushing it past the drawer stop into position.

To remove the crisper(s) cover:

1. Remove crisper drawers.

2. Holding the glass insert firmly with one hand, press up in

center of glass insert until it rises above the plastic frame.

Gently slide the glass insert forward to remove.

3. Lift the cover frame up and remove it.

To replace crisper(s) cover:

1. Fit back of cover frame into supports on side walls of the

refrigerator and lower the front of the cover frame into

place.

2. Slide rear of glass insert into cover frame and lower front

into place.

3. Replace crisper drawers.

Water and Ice Dispensers

IMPORTANT:

■ Allow 3 hours for the refrigerator to cool down and chill

water.

■ Allow 24 hours to produce the first batch of ice. Discard the

first three batches of ice produced.

■ The dispensing system will not operate when either the

refrigerator door or freezer drawer is open.

Flush the Water System

Air in the water dispensing system can cause the water

dispenser to drip. After connecting the refrigerator to a water

source or replacing the water filter, flush the water system.

Flushing the water dispensing system forces air from the water

line and filter and prepares the water filter for use. Additional

flushing may be required in some households.

NOTE: As air is cleared from the system, water may spurt out of

the dispenser.

1. Using a sturdy container, depress and hold the water

dispenser paddle for 5 seconds.

2. Release the dispenser paddle for 5 seconds. Repeat steps 1

and 2 until water begins to flow.

3. Once water begins to flow, continue depressing and

releasing the dispenser pad (5 seconds on, 5 seconds off)

until a total of 3 gal. (12 L) has been dispensed.

Calibrate Measured Fill

Household water pressure may affect the accuracy of the

Measured Fill feature. So, for optimum performance of your

water dispenser, you must first calibrate Measured Fill.

IMPORTANT:

■ Flush the water system before calibrating Measured Fill.

■ For best results, calibration should be performed when water

is not being used in the house.

1. Place a sturdy measuring cup (1 cup [237 mL] size) on the

dispenser tray centered in front of the ice/water dispenser

paddle.

NOTE: Depending on your model, a measuring cup may be

provided.

2. Press and hold the SETTINGS and LOCK buttons at the

same time for 3 seconds. The words “Back” and “1 Cup” will

appear on the display screen. Also, the Calibrate Measured

Fill icon will illuminate and remain lit while the Measured Fill

feature is being calibrated.

NOTE: You may press ICE/WATER “Back” at any time to

exit calibration mode. The Calibrate Measured Fill icon will

disappear.

A. Ice/Water dispenser paddle

B. Measuring cup (1 cup)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 107 108

Comments to this Manuals

No comments

Kenmore 26.2 cu. ft. French Door Refrigerator w/ Fresh Storage Drawer - Stainless Steel Owner's Manual Page 22

Comments to this Manuals

Related products and manuals for Fridges Kenmore 26.2 cu. ft. French Door Refrigerator w/ Fresh Storage Drawer - Stainless Steel