Kenmore 26.2 cu. ft. French Door Refrigerator w/ Fresh Storage Drawer - Stainless Steel Owner's Manual download pdf (Page 15)

Remove the Handles

1. While holding the handle, insert the short end of the hex key

into a setscrew hole and slightly rotate the hex key until it is

engaged in the setscrew.

2. Using a right to left motion loosen the setscrew a quarter-

turn at a time.

3. Repeat steps 1 and 2 for the other setscrew. Slowly pull the

handle away from the door or drawer.

4. If necessary, use a Phillips screwdriver to remove the

shoulder screws from the door.

Refrigerator Leveling, Door Closing and

Alignment

The base grille covers the adjustable brake feet and roller

assemblies located at the bottom of the refrigerator below the

freezer drawer. Before making any adjustments, remove the

base grille and move the refrigerator to its final location.

Tools Needed: ¹⁄₄" hex nut driver

Tools Provided: ¹⁄₈" hex key wrench

1. Remove the base grille. Using both hands, grasp the grille

firmly and pull it toward you. Open the freezer drawer to

access the brake feet.

NOTE: To allow the refrigerator to roll easier, raise the

brake feet by turning them counterclockwise. The front

rollers will be touching the floor.

2. Move the refrigerator to its final location.

3. Using the ¹⁄₄" hex nut driver, lower the brake feet. Turn them

clockwise, until the rollers are off the floor and both brake

feet are snug against the floor. This keeps the refrigerator

from rolling forward when opening the refrigerator doors or

freezer drawer.

IMPORTANT: If you need to make further adjustments

involving the brake feet, you must turn both brake feet the

same amount to keep the refrigerator level.

4. Make sure the doors close easily. If you are satisfied with the

door opening and closing, skip the next section and go to

“Align the Doors.” If, however, the doors do not close easily

or the doors pop open, adjust the tilt.

To Adjust the Cabinet Tilt:

■ Open the freezer drawer. Use a ¹⁄₄" hex nut driver to turn

both brake feet clockwise the same amount. This will

raise the front of the refrigerator. It may take several

turns to allow the doors to close easier.

NOTE: Having someone push against the top of the

refrigerator takes some weight off the brake feet. This

makes it easier to turn them.

Style 1

Style 2

5. Make sure the doors are even at the top and that the space

between the bottom of the refrigerator doors and the top of

the freezer drawer is even. If necessary, align the doors.

To Align the Doors:

■ Keeping both refrigerator doors closed, pull out the

refrigerated drawer. Locate the bottom hinge pin of the

righthand refrigerator door. The alignment screw is

inside the bottom hinge pin.

A. Brake foot

B. Front roller

A. Brake foot

A. Bottom hinge pin

B. Turn to the right to raise.

C. Turn to the left to lower.

D. ¹⁄₈" Hex key wrench

¹⁄₄"

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 107 108

Comments to this Manuals

No comments

Kenmore 26.2 cu. ft. French Door Refrigerator w/ Fresh Storage Drawer - Stainless Steel Owner's Manual Page 15

Comments to this Manuals

Related products and manuals for Fridges Kenmore 26.2 cu. ft. French Door Refrigerator w/ Fresh Storage Drawer - Stainless Steel