Kenmore 25 cu. ft. Side-by-Side Refrigerator w/ SmartSense Cooling Technology - Bisque ENERGY STAR Owner's Manual download pdf (Page 14)

If you need to adjust temperatures in the refrigerator or freezer,

use the settings listed in the chart below as a guide. Wait at

least 24 hours between adjustments.

Water and Ice Dispensers

Depending on your model, you may have one or more of the

following options: the ability to select either crushed or cubed

ice, a special light that turns on when you use the dispenser, or a

lock option to avoid unintentional dispensing.

NOTES:

■ The dispensing system will not operate when either door

(refrigerator or freezer) is open.

■ Allow 24 hours for the refrigerator to cool down and chill

water.

■ Allow 24 hours to produce the first batch of ice. Discard the

first three batches of ice produced. Wait 72 hours for full

ice production. Also, take large amounts of ice from the ice

bin, not through the dispenser.

Flush the Water System

Air in the water dispensing system can cause the water

dispenser to drip. After connecting the refrigerator to a water

source or replacing the water filter, flush the water system.

Flushing the water dispensing system forces air from the water

line and filter, and prepares the water filter for use.

NOTE: As air is cleared from the system, water may spurt out of

the dispenser.

1. Using a sturdy container, depress and hold the water

dispenser lever for 5 seconds, then release it for 5 seconds.

2. Repeat Step 1 until water begins to flow.

3. Once water begins to flow, continue depressing and

releasing the dispenser lever (5 seconds on, 5 seconds off)

until a total of 3 gal. (12 L) has been dispensed.

Additional flushing may be required in some households.

The Water Dispenser

IMPORTANT:

■ Dispense at least 1 qt (1 L) of water every week to maintain a

fresh supply.

■ If the flow of water from the dispenser decreases, it could be

caused by low water pressure.

■ With the water filter removed, dispense 1 cup (237 mL)

of water. If 1 cup of water is dispensed in 8 seconds or

less, the water pressure to the refrigerator meets the

minimum requirement.

■ If it takes longer than 8 seconds to dispense 1 cup of

water, the water pressure to the refrigerator is lower

than recommended. See “Water Supply Requirements”

or “Problem Solver” for suggestions.

To Dispense Water:

1. Press the WATER button to select water.

Style 1:

Style 2:

2. Press a sturdy glass against the dispenser lever. Hold the

glass close to the water dispenser spout to ensure that the

water dispenses into the glass.

3. Remove the glass to stop dispensing.

IMPORTANT: The small tray at the bottom of the dispenser is

designed to catch small spills and allow for easy cleaning. There

is no drain in the tray. To empty and clean the tray, push down

on the back of the removable tray lid and pull it out.

The Ice Dispenser

Ice dispenses from the ice maker storage bin in the freezer.

When the dispenser lever is pressed, a trap door opens in a

chute between the dispenser and the ice bin. Ice moves from the

bin and falls through the chute. When you release the dispenser

lever, the trap door closes and the ice dispensing stops.

Some models dispense both cubed and crushed ice. Before

dispensing ice, select which type of ice you prefer.

CONDITION/REASON: ADJUSTMENT:

REFRIGERATOR too warm REFRIGERATOR Control

one setting higher

FREEZER too warm/

too little ice

FREEZER Control

one setting higher

REFRIGERATOR too cold REFRIGERATOR Control

one setting lower

FREEZER too cold FREEZER Control

one setting lower

A. Water dispenser spout

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 87 88

Comments to this Manuals

No comments

Kenmore 25 cu. ft. Side-by-Side Refrigerator w/ SmartSense Cooling Technology - Bisque ENERGY STAR Owner's Manual Page 14

Comments to this Manuals

Related products and manuals for Fridges Kenmore 25 cu. ft. Side-by-Side Refrigerator w/ SmartSense Cooling Technology - Bisque ENERGY STAR