Kenmore 385.16677 User Manual download pdf (Page 33)

Adjustment of Needle Plate Setting Knob

(Changing to Standard Serging or Rolled

Hemming)

1. Turn off the power switch and unplug the

machine.

2. Open the looper cover and side cover.

3. Deactivate the upper knife.

4. Push the cutting width adjusting dial to the right

as far as it will go, then, move the needle plate

setting knob to the guide line of S (for Standard

Serging) or R (for Rolled Hemming).

Release the cutting width adjusting dial to the left

gently.

5. Set the upper knife to up position.

6. Close the looper cover and side cover.

(?) Chaining finger

(D Guide line

@ Cutting width adjusting dia

(4) Upper knife

(D Needle plate setting knob

(A) Standard Serging

The chaining finger is. iobated beside: :the needle

plate as shown in diagram (A) for guiding the flat

edge of the. fabric for overlook;sewing: ■

(B) Roiled Hemming

Pull the needle plate setting knob from “S” to “R”

position, so that the fabric edge will be rolled for

hemming, picot edging, and narrow hemming.

(B)

■CD

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 89 90

No comments

Kenmore 385.16677 User Manual Page 33