Kenmore 385.16677 User Manual download pdf (Page 31)

Adjustment of Cutting Width

When cutting width is too narrow or too wide against

seam width, adjust it as follows.

1. Turn off the power switch and unplug the

machine.

2. Open the looper cover and side cover.

3. Set the upper knife to down position

4. Turn the cutting width adjusting dial to get

desired position of lower knife.

(T) Cutting width adjusting dial

(2) Lower knife

@ Standard setting

The cutting width of this model eah be adjusted

approximately 3.0 to 5.0 mm; from the right

needle position depending upon your sewing

needs or the fabric being used:.. . :

(The cutting widBilililld be'adjusted to get the

same resu.lts.a.s in drawing 4

When cuttin|iiijith is too narrow:

Turn cutting width:.adjusting dial ciockwise (A).

Lower knife w|i;|ii|g to right,;:- If

When cutting width is too wide.

Turn the cutting width adjusting dial counterclockwise

(B).

Lower knife will move to left.

5. Set the upper knife to up position.

6. Close the looper cover and side cover.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 89 90

No comments

Kenmore 385.16677 User Manual Page 31