Kenmore Washer/Dryer User Manual download pdf (Page 37)

REVIEW INSTALLATION

for your Benefit

Take a few minutes to complete

this checklist. It will help assure you

that you have a proper installation

and will increase your satisfaction

with your Kenmore laundry center.

□ Check electrical requirements.

Be sure you have correct electrical

supply and recommended grounding

method.

□ Check that you have:

• All the tools you started with.

• Removed all packaging materials.

• Removed shipping strap with

three cotter pins.

• Installed all parts listed on

pages 5-10.

□ Check that:

• The laundry center is level.

• The nuts on the front legs are tight.

□ Check that the water faucets are

turned on.

□ Ensure that laundry center is

positioned in its final location. Make

sure vent is not crushed or kinked.

FINAL STEPS

□ Plug the power supply cord into the

grounded outlet or connect direct wire

to power supply.

□ Turn power supply on.

□ Wipe the interior of the dryer drum

thoroughly with a damp cloth to

remove any dust.

□ Remove the blue protective film on

the console and any tape remaining

on laundry center.

□ Take a few minutes and read the

Operating Instructions (pages 38-48)

to fully understand your new laundry

center.

□ Start the washer and allow it to com

plete the HEAVY DUTY Cycle.

□ Start the dryer and allow it to complete

a full heat cycle (not the air cycle).

After five minutes, open dryer door.

You should feel heat inside the dryer.

If you do not feel heat, see Trouble

shooting information on pages 63-64.

NOTE: You may notioe a burning

odor. This smell is common when

the heating element is first used.

The smell will go away.

37

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 65 66

Comments to this Manuals

No comments