Kenmore Washer/Dryer User Manual download pdf (Page 31)

G. SECURE DRAIN HOSE

H. LEVEL LAUNDRY CENTER

/or 1/oiif Benefit

Securing the drain hose properly will

protect your floors from damage due

to water leakage.

STEP 1. Move laundry center to its final

location.

STEP 2. Locate the remaining piece

of shipping strap (not the end with

the three cotter pins) from STEP 3 of

“REMOVE SHIPPING STRAP.” Use

it to wrap the drain hose together with

the laundry tub or standpipe. Push

fastener into the nearest hole in the

shipping strap.

If the water faucets and drain standpipe

are recessed, put hooked end of drain

hose in standpipe. Tightly wrap the

shipping strap around the drain hose

and water inlet hoses (not the handles

or stems). Push fastener into the

nearest hole in the shipping strap.

for your Benefit

Leveling your laundry center

properly prevents excessive

noise and vibration.

STEP 1. Tilt laundry center forward

until rear of laundry center is at least

3 inches off floor. You may hear the

self-adjusting rear legs click into place.

Lower laundry center to floor. Check

levelness of the laundry center by

placing a leve on top of the washer,

first side-to-side; then front-to-back.

STEP 2. If laundry center is not level,

prop up the front of the laundr/ center

and adjust the legs up or down as

necessary. Lower laundry center and

reset self-adjusting rear legs (as in

STEP 1). Repeat STEP 2 until the

laundry center is level.

NOTE: Do not tighten the front leg nuts

until after you have connected your

exhaust system (see pages 32-36).

31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 65 66

Comments to this Manuals

No comments