Kenmore Washer/Dryer User Manual download pdf (Page 21)

ALTERNATE CONNECTION:

If local codes do not permit the

connection of a frame-grounding

conductor to the neutral wire:

STEP 1. Disconnect power.

STEP 2. Make sure the power supply

cord or direct wire cable is in place

(see steps 1 -3 on page 18 for power

cord connections or steps 1-3 on pages

19-20 for direct wire connection).

STEP 3. Remove the neutral grounding

wire (green/yellow wire) from external

grounding connector screw. Loosen or

remove terminal block screws. Connect

neutral grounding wire and the neutral

wire (white or center) of power supply

cord or direct wire cable under the center

screw of the terminal block.

STEP 4. Connect the other two wires

to outer terminal block screws. Securely

tighten all electrical connections.

STEP 5. Tighten the strain relief screws.

STEP 6. Insert tab of terminal block

cover into slot of the laundry center

rear panel. Secure cover with hold

down screw.

STEP 7. Connect separate copper

grounding wire from external ground

connector to an adequate ground. If

codes permit and a separate grounding

wire is used, it is recommended that a

qualified electrician determine that the

grounding path is adequate.

Proceed with Installation on page 27.

Neutral

grounding wire

(green/yellow)

External

ground

connector

Grounding path

determined by a

qualified electrician

Alternate 3-Wire Connection with

External-Grounding Conductor

21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 65 66

Comments to this Manuals

No comments