Kenmore Washer/Dryer User Manual download pdf (Page 32)

I. CONNECT EXHAUST

for t/om-Benefit

A properly exhausted laundry center

will give you the shortest drying time,

lower your utility bill, and extend the

life of the laundry center.

A WARNING

M

Fire Hazard

Use a heavy metal vent.

Do not use a plastic vent.

Do not use a metal foil vent.

Failure to follow these instructions

can result in death or fire.

Typiii^l installations exhaust from the

rear of the laundry center.

Avoid pushing the laundiy center tightly

against a wall. This can crush or kink the

vent. Use the straightest path you can,

where possible. Avoid 90° turns.

ROUTE THE VENT

WARNING: To reduce the risk of fire,

this dryer must be exhausted outdoors.

• Use a heavy metal vent.

• Do not use a plastic vent.

• Do not use a metal foil vent.

• Do not exhaust laundry center into

a chimney, a wall, a ceiling, or a

concealed space of a building.

• The diameter of the heavy metal vent

must be 4 inches.

• Do not use an exhaust hood with a

magnetic latch.

• If using an existing exhaust system,

disconnect vent from the laundry center

and clean one section at a time until you

reach the exhaust hood. To clean out

lint, you can use the hose attachment

on your vacuum or, use a pole or wire

with a feather duster or rag attached.

•

Rear exhaust installations for standard

offs(;t connections - (see pigs. 34-35)

• Make sure exhaust hood is not plugged

with lint. Follow the instructions in this

section to reinstall your vent system.

Bear exhaust installations for offset

connections with close clearances -

(see p. 36)

32

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 65 66

Comments to this Manuals

No comments