Kenmore 26.5 cu. ft. Side-by-Side Refrigerator - Bisque Owner's Manual download pdf (Page 14)

Installing the Filter Status Indicator (on some models)

The filter comes with a status indicator, which should be

activated and installed at the same time the air filter is installed.

1. Place the indicator face-down on a firm, flat surface.

2. Apply pressure to the bubble on the back of the indicator,

until the bubble pops to activate the indicator.

3. Lift open the vented air filter door. There are notches behind

the door. Slide the indicator down into the notches, facing

outward.

NOTE: The indicator will not easily slide into the notches if

the rear bubble has not been popped.

4. Close the air filter door, and check that the indicator is

visible through the rectangular hole in the door.

Replacing the Air Filter

The disposable air filter should be replaced every 6 months,

when the status indicator has completely changed from white to

red.

To order a replacement air filter, see “Accessories.”

1. Remove the old air filter by squeezing in on the side tabs.

2. Remove the old status indicator.

3. Install the new air filter and status indicator using the

instructions in the previous sections.

REFRIGERATOR USE

Ensuring Proper Air Circulation

In order to ensure proper temperatures, you need to permit air

to flow between the two sections. Cold air enters the bottom of

the freezer section and moves up. It then enters the refrigerator

section through the top vent. On Style 2 models, this air is also

evenly distributed throughout the refrigerator compartment

through six vents on the back wall. Air then returns to the freezer

as shown.

Do not block any of these vents with food such as soda, cereal,

bread, etc. If the vents are blocked, airflow will be obstructed

and temperature and moisture problems may occur.

IMPORTANT: Because air circulates between both sections, any

odors formed in one section will transfer to the other. You must

thoroughly clean both sections to eliminate odors. To avoid odor

transfer and drying out of food, wrap or cover foods tightly.

Using the Controls

The refrigerator and freezer controls are located on the

dispenser panel.

IMPORTANT: The display screen on the dispenser control panel

will turn off automatically and enter “sleep” mode when the

control buttons and dispenser pad have not been used for

2 minutes or more. While in “sleep” mode, the first press of a

control button will only reactivate the display screen, without

changing any settings.

■ Touch any control button on the dispenser panel to activate

the display screen. The home screen will appear as shown.

MONTHS

REPLACE

Style 1 Style 2

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 95 96

Comments to this Manuals

No comments

Kenmore 26.5 cu. ft. Side-by-Side Refrigerator - Bisque Owner's Manual Page 14

Comments to this Manuals

Related products and manuals for Fridges Kenmore 26.5 cu. ft. Side-by-Side Refrigerator - Bisque