Kenmore 26.5 cu. ft. Side-by-Side Refrigerator - Bisque Owner's Manual download pdf (Page 13)

Complete the Installation

1. Plug into a grounded 3 prong outlet.

2. Flush the water system. See “Prepare the Water System” or

“Water and Ice Dispensers.”

NOTE: Allow 24 hours to produce the first batch of ice. Allow

72 hours to completely fill ice container.

Prepare the Water System

Please read before using the water system.

Immediately after installation, follow the steps below to make

sure that the water system is properly cleaned.

1. Open the freezer door and turn off the ice maker. The On/

Off switch can only be accessed when the ice storage bin

has been removed. The switch is located on the freezer door,

on the left side of the wall that surrounds the ice storage bin.

Move the switch to the OFF (right) setting.

2. Make sure the water filter is properly installed.

3. Flush the water system. Use a sturdy container to depress

and hold the water dispenser lever for 5 seconds, then

release it for 5 seconds. Repeat until water begins to flow.

Once water begins to flow, continue depressing and

releasing the dispenser lever (5 seconds on, 5 seconds off)

until a total of 3 gal. (12 L) has been dispensed. This will

flush air from the filter and water dispensing system, and

prepare the water filter for use. Additional flushing may be

required in some households. As air is cleared from the

system, water may spurt out of the dispenser.

4. Open the freezer door and turn on the ice maker. Move the

switch to the ON (left) position. Please refer to the “Ice

Maker and Storage Bin” section for further instructions on

the operation of your ice maker.

■ Allow 24 hours to produce the first batch of ice.

■ Discard the first three batches of ice produced.

■ Depending on your model, you may want to select the

maximum ice feature to increase the production of ice.

Install CleanFlow™ Air Filter

(on some models)

On some models, your refrigerator's accessory packet includes

an air filter, which must be installed prior to use. On some

models, the air filter is already installed at the factory.

The air filter reduces the buildup of odors. This helps to maintain

a cleaner environment inside the refrigerator.

Installing the Air Filter (on some models)

The filter should be installed behind the vented door, which is

located (depending on your model) along either the rear or left

interior wall near the top of the refrigerator compartment.

1. Remove the air filter from its packaging.

2. Lift open the vented door.

3. Snap the filter into place.

4. Close the vented door.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

WARNING

Do not use with water that is microbiologically unsafe or

of unknown quality without adequate disinfection before

or after the system. Systems certified for cyst reduction

may be used on disinfected waters that may contain

filterable cysts.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 95 96

Comments to this Manuals

No comments

Kenmore 26.5 cu. ft. Side-by-Side Refrigerator - Bisque Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Fridges Kenmore 26.5 cu. ft. Side-by-Side Refrigerator - Bisque