Kenmore 77022 Owner's Manual download pdf (Page 26)

REVERSING DRYER DOOR SWING (OPTIONAL)

9. Attach door hinges to dryer door so that larger hole is

at the bottom of the hinge and the hinge pin is toward the

door front.

10. Remove the four screws that attach two plugs on the left side.

Attach plugs to right side using the same four screws.

11. Insert screws into bottom holes on left side of cabinet. Tighten

screws halfway. Position door so large end of door hinge slot

is over screws. Slide door up so screws are in bottom of slots.

Tighten screws. Insert and tighten top screws in hinges.

12. Close door and check that door strike aligns with door catch.

If needed, slide door catch left or right within slot to adjust

alignment.

You can change your door swing from a right-side opening

to left-side opening, if desired.

Remove the Door Assembly

1. Place a towel or soft cloth on top of dryer or work space

to avoid scratching of the surface.

2. Open dryer door. Remove bottom screws from cabinet side

of hinges. Loosen (do not remove) top screws from cabinet

side of hinges.

3. Lift door until top screws in cabinet are in large part of hinge

slot.Pullforwardoscrews.Setdoor(handlesideup)ontop

of dryer. Remove top screws from cabinet.

4. Remove screws attaching hinges to door.

5.Removescrewsattop,bottom,andsideofdoor(vescrews).

6. Holding door over towel on dryer, grasp sides of outer door

and gently lift to separate it from inner door. Do not use a

putty knife to pry apart. Do not pull on door seal or plastic

door catch.

7. Be certain to keep cardboard spacer centered between doors.

Reattach outer door panel to inner door panel so handle is on

the side where hinges were just removed.

8. Reattachscrewsattop,bottom,andsideofdoor(vescrews).

Towel

Hinges

(Appearance may vary)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 59 60

No comments

Kenmore 77022 Owner's Manual Page 26