Kenmore 77022 Owner's Manual Page 11
- Page / 60
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
11
Your dryer can be installed in a basement, laundry room, or
recessed area.
Companion appliance location requirements should also be
considered.
IMPORTANT: Do not install or store the dryer where it will be
exposed to the weather. Proper installation is your responsibility.
You will need:
■ A grounded electrical outlet located within 6 ft. (1.8 m) of
where the power cord is attached to the back of the dryer.
See “Electrical Requirements.”
■ Aleveloorwithamaximumslopeof1"(25mm)under
entiredryer.Installingthedryeronsoftoorsurfaces,suchas
carpets or surfaces with foam backing, is not recommended.
Electric dryer installation clearances
■ The location must be large enough to allow the dryer door
to be fully opened.
■ Additional spacing should be considered for ease of
installation and servicing. The door opens more than 180°.
■ Additional clearances might be required for wall, door,
andoormoldings.
■ Additionalspacingof1"(25mm)onallsidesofthedryer
is recommended to reduce noise transfer.
Recessed Area and Closet Installation Instructions
This dryer may be installed in a recessed area or closet. For
recessed area and closet installations, minimum clearances
can be found on the warning label on the rear of the dryer
or in “Dimensions/Clearances.”
The installation spacing is in inches and is the minimum
allowable. Additional spacing should be considered for ease
of installation, servicing, and compliance with local codes
and ordinances.
If closet door is installed, the minimum unobstructed air
opening in the top and bottom is required. Louvered doors
with equivalent air openings are acceptable.
Location Requirements
The dryer must be exhausted outdoors.
24 in.
2
(155 cm
2
)
48 in.
2
(310 cm
2
)
3"
(76 mm)
3"
(76 mm
)
Closet
door
Front
View
ELECTRIC DRYER INSTALLATION REQUIREMENTS
Closet
Door
Front
View
Electrical Requirements – U.S.A. only
It is your responsibility:
■ Tocontactaqualiedelectricalinstaller.
■ To be sure that the electrical connection is adequate and in
conformance with the National Electrical Code, ANSI/NFPA
70-latest edition and all local codes and ordinances.
■ The National Electrical Code requires a 4-wire power supply
connection for homes built after 1996, dryer circuits involved
in remodeling after 1996, and all mobile home installations.
■ A copy of the above code standards can be obtained from:
National Fire Protection Association, One Batterymarch Park,
Quincy, MA 02269.
■ To supply the required 3- or 4-wire, single phase, 120-/240-
volt, 60 Hz., AC-only electrical supply (or 3- or 4-wire,
120-/208-voltelectricalsupply,ifspeciedontheserial/
rating plate) on a separate 30-amp circuit, fused on both
sides of the line. A time delay fuse or circuit breaker is
recommended. Connect to an individual branch circuit.
Do not have a fuse in the neutral or grounding circuit.
■ Do not use an extension cord.
■ If codes permit and a separate ground wire is used, it is
recommendedthataqualiedelectriciandeterminethat
the ground path is adequate.
Mobile home – Additional installation requirements:
This dryer is suitable for mobile home installations. The
installation must conform to the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile home construction
and Safety, Title 24, HUD Part 280).
Mobile home installations require:
■ Metal exhaust system hardware, available for purchase
from your dealer. For further information, see “Assistance
or Service” section in your Use and Care Guide.
■ Special provisions must be made in mobile homes to
introduce outside air into dryer. Openings (such as a
nearby window) should be at least twice as large as
dryer exhaust opening.
- Commercial Dryer 1
- Table of Contents 2
- DRYER SAFETY 3
- TOOLS & PARTS 6
- DIMENSIONS/CLEARANCES 7
- Electrical Requirements 9
- Gas Supply 10
- Location Requirements 11
- Electrical Connection 12
- Electric Dryer Grounding 12
- Direct Wire 13
- If connecting by direct wire: 13
- DRYER VENTING REQUIREMENTS 14
- GAS SUPPLY CONNECTION 16
- AND COIN BOX 18
- 5" 19
- (127 mm) 19
- Direct Wire Connection 21
- Connecting Neutral Wire 23
- LEVELING 24
- COMPLETE INSTALLATION 25
- Remove the Door Assembly 26
- Electrical Shock Hazard 27
- MAINTENANCE INSTRUCTIONS 28
- KENMORE APPLIANCE WARRANTY 29
- SEGURIDAD DE LA SECADORA 30
- HERRAMIENTAS Y PIEZAS 33
- DIMENSIONES Y ESPACIOS LIBRES 34
- Requisitos de ubicación 35
- Requisitos eléctricos 36
- ADVERTENCIA 37
- REQUISITOS DE INSTALACIÓN 38
- DE LA SECADORA ELÉCTRICA 38
- Capotas de ventilación 42
- * Espacio mínimo por encima 43
- Tipo de gas 44
- Línea de suministro de gas 44
- 1" 46
- Conexión por cable directo 49
- NIVELACIÓN 52
- COMPLETE LA INSTALACIÓN 53
- DE LA SECADORA (OPCIONAL) 54
- (en algunos modelos) 55
- GARANTÍA LIMITADA DE KENMORE 57
- DE RECURSOS 57
- Kenmore ® 60
Related products and manuals for Electric laundry dryers Kenmore 77022
(40 pages)South Shore Furniture 9016062 manuels
Manuels d'utilisation et guides de l'utilisateur pour Non South Shore Furniture 9016062.
Nous fournissons des manuels en pdf 1 South Shore Furniture 9016062 à télécharger gratuitement par type de document : Manuel d'instructions
Comments to this Manuals