Kenmore 77022 Owner's Manual download pdf (Page 25)

1. Check the electrical requirements. Be sure that you have the

correct electrical supply and the recommended grounding

method. See “Electrical Requirements.”

2. Check that all parts are now installed. If there is an extra part,

go back through the steps.

3. Check that you have all of your tools.

4. Dispose of/recycle all packaging materials.

5. Plug into a grounded outlet, or connect power.

6. Check dryer operation (on some models, some accumulated

time may be on the timer due to factory testing). Close dryer

door. Depending on model, turn timer-set knob to the right

or insert coins and press slide in slowly. (Operating time will

accumulate per number of coinslide depressions, depending on

model, and type of timing cam used.) Push START button. Using

a full heat cycle (not the air cycle), let the dryer run for

atleast5minutes.Dryerwillstopwhentimeisusedup.

NOTE: Dryer door must be closed for dryer to operate.

When door is open, dryer stops, but timer continues to run.

To restart dryer, close door and push START button.

7. Open the dryer door. Check that the inside of the dryer is

warm. If the burner does not ignite and you can feel no heat

insidethedryer,shutothedryerfor5minutes.Checkthatall

supply valve controls are in On position and that the electrical

cordispluggedin.Repeat5-minutetest.

8. If drying time is too long, make sure that the lint screen is

cleanandthattherearenoobstructionstoairowinthedryer

vent system.

9. Restart the dryer and allow it to complete a full heat cycle

(not air cycle) to make sure it is working properly.

COMPLETE INSTALLATION

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

No comments

Kenmore 77022 Owner's Manual Page 25