Kenmore 77022 Owner's Manual download pdf (Page 14)

DRYER VENTING REQUIREMENTS

WARNING: Toreducetheriskofre,thisdryerMUSTBE

EXHAUSTED OUTDOORS.

IMPORTANT: Observe all governing codes and ordinances.

Dryer exhaust must not be connected into any gas vent,

chimney, wall, ceiling, attic, crawlspace, or concealed space

ofabuilding.Onlyrigidorexiblemetalventshallbeused

for exhausting.

■ Onlya4"(102mm)heavy,metalexhaustventandclamps

may be used.

■ Do not use plastic or metal foil vent.

Rigid metal vent:

■ Recommended for best drying performance and to avoid

crushing and kinking.

Flexible metal vent: (Acceptable only if accessible to clean)

■ Mustbefullyextendedandsupportedinnaldryerlocation.

■ Remove excess to avoid sagging and kinking that may result

inreducedairowandpoorperformance.

■ Donotinstallinenclosedwalls,ceilings,oroors.

■ The total length should not exceed 7

⁄

ft. (2.4 m).

NOTE: If using an existing vent system, clean lint from entire

length of the system and make sure exhaust hood is not plugged

with lint. Replace plastic or metal foil vents with rigid metal

orexiblemetalvents.Review“VentSystemChart”and,if

necessary, modify existing vent system to achieve best drying

performance.

(102 mm)

4" (102 mm) Heavy, Metal Exhaust Vent

Elbows:

■ 45°elbowsprovidebetterairowthan90°elbows.

Clamps:

■ Use clamps to seal all joints.

■ Exhaust vent must not be connected or secured with screws

or other fastening devices that extend into interior of duct

and catch lint. Do not use duct tape.

Better

Good

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

No comments

Kenmore 77022 Owner's Manual Page 14