Kenmore 77022 Owner's Manual download pdf (Page 18)

INSTALLING LEVELING LEGS, COIN SLIDE,

AND COIN BOX

1. Prepare dryer for leveling legs

NOTE: Slide dryer onto cardboard or hardboard before moving

toavoiddamagingoorcovering.

Using two or more people, move dryer to desired installation

location.

Taketapeofrontcornersofdryer.Opendryerandremove

the literature and parts packages. Wipe drum interior with a

damp cloth to remove any dust.

Take two cardboard corners from the dryer carton and place

themontheoorinbackofthedryer.Firmlygraspthebodyof

the dryer and gently lay it on its back on the cardboard corners.

1. Install coin slide and coin box

Remove the service door of the meter case by lifting it up

at the back. Install the money-accepting device. (Refer to

manufacturer’s instructions for proper installation.)

For dryers using coin slides, use the adapter kit supplied

with the dryer.

Install the meter case service door. Put the coin box

with lock and key in the meter case opening.

Remove cardboard or hardboard from under dryer. Adjust

the legs of the dryer up or down until the dryer is level.

2. Install added security device

Check that power is not supplied to the dryer.

Open and remove the service door.

Insert the narrow part of the security cone into the oblong hole

in the bottom rear of the meter case assembly.

Pass the security bolt through this cone and thread it by hand

into the cage nut below the oblong hole.

Tighten the security bolt by hand a few turns before using a

wrench to tighten until snug.

(Appearance may vary)

security

bolt

security

cone

cage nut

NOTE: Installing the security bolt provides added security, but

will add to the service time when the top needs to be removed

or lifted for servicing the dryer.

Security

Bolt

Security

Cone

Cage

Nut

2. Screw in leveling legs

Examinelevelinglegsandnddiamond

marking. Screw legs into leg holes by

hand. Use an adjustable wrench or

1"(25mm)hex-headsocketwrench

tonishturninglegsuntildiamond

markingisnolongervisible.Thent

a covered foot boot over each leg foot.

Toprotecttheoor,usealargepieceofcardboardfromthe

dryer carton. Stand dryer up on the cardboard. Slide the dryer

untilitisclosetoitsnallocation.Leaveenoughroomfor

electrical connection and to connect the exhaust vent.

A longer leveling foot is available if needed on extremely sloped

oors,PartNumber279810.

Foot

Diamond

Marking

On some models: The meter case houses the factory-installed

accumulator timer with actuating arm or service switch.

Thefactory-installedtimerissettoprovide45minutes(4pins)

of drying time when activated by the coin slide. Timer cams

for 30-minute (6 pins) and 60-minute (3 pins) drying times are

included in the parts bag.

The coin slide mechanism, service door lock and key, and coin

box lock and key may not be included but are available from

the usual industry sources.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

Comments to this Manuals

No comments

Kenmore 77022 Owner's Manual Page 18

Comments to this Manuals

Related products and manuals for Electric laundry dryers Kenmore 77022