Kenmore 77022 Owner's Manual download pdf (Page 23)

2. Place hooked end of neutral wire (white or center wire) (D) of

direct wire cable under center terminal block screw (A), hook

facing right. Squeeze hooked end together and tighten screw.

3. Connect remaining wires under outer terminal block screws

(F). Squeeze hooked ends together and tighten screws. Finally,

reinstall terminal block to dryer rear panel. Secure cover with

hold-down screw.

Use where local codes permit connecting cabinet-ground

conductor to neutral wire.

Directwirecablemusthave5ft.(1.52m)ofextralengthsodryer

can be moved if needed.

Strip 3

⁄

"(89mm)ofoutercoveringfromendofcable.Strip

insulationback1"(25mm).Ifusing3-wirecablewithground

wire, cut bare wire even with outer covering. Shape ends of

wires into a hook shape.

Connecting Neutral Wire

1. Loosen or remove center terminal block screw (A).

Connecting 3-Wire Connection: Direct Wire

ELECTRIC DRYER ELECTRICAL CONNECTIONS

3. Connect remaining wires under outer terminal block screws

(F). Tighten screws.

4. Connect a separate copper ground wire (G) under the green

external ground conductor screw (C) to an adequate ground.

Finally, reinstall terminal block to dryer rear panel. Secure

cover with hold-down screw.

Connecting Neutral Wire

1. Remove center terminal block screw (A). Also remove neutral

ground wire (B) by removing green external ground conductor

screw (C).

2. Connect neutral ground wire (B) and neutral wire (white or

center wire) (D) of power supply cord/cable under center

terminal block screw (A). Tighten screw.

Connecting 3-Wire Connection: Optional

Use for direct wire or power supply cord where local codes do not permit connecting cabinet-ground conductor to neutral wire.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

No comments

Kenmore 77022 Owner's Manual Page 23