Kenmore 200 User Manual download pdf (Page 22)

Threading the Machine

• Threading the machine

* Raise the thread take-up lever to its highest position by

turning the handwheel counterclockwise.

* Raise the presser foot lifter.

* Piace a spool on the spool pin, with the thread coming

off from the bottom toward the front of the sewing

machine.

Q] Draw the end of the thread around the upper thread guide.

[U While holding the thread near the spool, draw the end of

the thread down around the check spring holder.

[U Firmly draw the thread up to the take-up lever, and down

into the take-up lever eye.

d] Pass the thread behind the lower thread guide on the left.

[U Slip the thread in the needle bar thread guide on the left.

Thread the needle from front to back, or use the built-in

needle threader.

Built-in needle threader

(T) Knob

(2) Hook

Q Raise the needle to its highest position. Push down the

needle threader knob (T) as far as it will go.

The hook comes out through the needle eye from

behind.

[] Paying close attention to the needle point, draw the

thread around the guide and under the hook (2).

3] Release the knob slowly while holding the thread end

with your hand. A loop of the thread is pulled up through

the needle eye.

Note;

The needle threader can be used with a #11 to #16

needle, or a #11 Blue needle.

Thread size 50 to 100 is recommended.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 89 90

No comments

Kenmore 200 User Manual Page 22