Kenmore 200 User Manual download pdf (Page 14)

Thread Cutter

(T) Thread cutter

You do not need a pair of scissors to cut threads after

sewing. Just use the built-in thread cutter (T).

Changing Needle

(T) Fiat side

(D Needle damp screw

(3) Needle damp

[T] Turn off the power switch.

Raise the needle to its highest position by turning the

handwheei counterclockwise, toward you, and lowering

the presser foot. Loosen the needle clamp screw (2) by

turning it counterclockwise. Remove the needle from the

needle clamp (3).

[2] Insert a new needle Into the needle damp (3) with the

flat side ® to the rear. When inserting the needle into

the needle clamp (3), push it up as far as it goes. Tighten

the needle clamp screw (2) firmly by turning it clockwise.

[U To check for a good needle, place the flat side of the

needle onto something fiat (needle plate, glass, etc.).

The gap between the needle and the fiat surface should

be consistent. Never use a bent or blunt needle.

A damaged needle can cause permanent snags or runs

in knits, fine silks and silk-like fabrics.

Changing Presser Foot

(T) Snap-on button (red button)

(D Groove

CD Pin

• To remove

Raise the needle to its highest position by turning the

handwheel counterclockwise. Raise the presser foot, and

press the red button ® on the back of the foot holder.

• To attach

Place a selected presser foot so the pin (3) on the foot lies

Just under the groove (D on the foot holder. Lower the

presser bar to lock the foot in place.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 89 90

No comments

Kenmore 200 User Manual Page 14