Kenmore 26-41262 Owner's Manual download pdf (Page 25)

Cleaning the Water Inlet Filters

If the washer does not ﬁll properly, an error message will

show on the display. The inlet valve ﬁlter screens could

be plugged by hard water scale, sediment in the water

supply, or other debris.

NOTE: The inlet screens protect the delicate parts of the

inlet valve from being damaged by particles that could

enter the valves with the water supply. Operating the

washer with these ﬁlters removed could cause a valve

to fail to open, resulting in ﬂooding and/or property

damage.

Turn OFF both water faucets completely. Unscrew

the hot and cold water lines from the back of the

washer.

MAINTENANCE

CARE AND CLEANING

Carefully remove the ﬁlters from the water valves

and soak them in white vinegar or a lime scale

remover, following the manufacturer’s instructions.

Be careful not to damage the ﬁlters while cleaning.

Rinse thoroughly before reinstalling. Press the ﬁlters

back into place.

Before reattaching the hoses, ﬂush the hoses and

water lines by running several gallons of water

through the hoses and into a bucket or drain.

Inlet Filter

IMPORTANT: ONLY use new, high-quality inlet hoses

when installing this laundry product. Aftermarket hoses

are not guaranteed to ﬁt or function correctly. Other

hoses may not tighten correctly and could cause leaks.

Subsequent damage to product or property will not be

covered under the terms of the product warranty.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 63 64

No comments

Kenmore 26-41262 Owner's Manual Page 25