Kenmore 26-41262 Owner's Manual download pdf (Page 8)

When removing the washer from the carton base, be

sure to remove the foam drum support in the middle of

the carton base. See drawing below.

If you must lay the washer down to remove the base

packaging materials, always protect the side of the

washer and lay it carefully on its side. DO NOT lay the

washer on its front or back.

To prevent internal damage during transport, the washer

is equipped with four shipping bolts and plastic retainers.

IMPORTANT:

These shipping bolts and retainers • MUST NOT be

removed until just before moving the washer into its

ﬁnal position.

These bolts and retainers • MUST be removed before

operating the washer.

Failure to remove shipping bolts and retainers may •

cause severe vibration and noise, which can lead to

permanent damage to the washer.

NOTE: The power cord is secured to the back of the

washer with a shipping bolt to help prevent operation

with shipping bolts in place.

1. Starting with the bottom two shipping bolts, use the

wrench (included) to fully loosen all four shipping

bolts by turning them counterclockwise.

2. Remove the bolt assemblies by wiggling them

slightly while pulling.

3. Locate the four hole caps included in the accessory

pack and install them in the shipping bolt holes.

NOTE: Save the bolt assemblies for future use. To

prevent damage to internal components, DO NOT

transport the washer without reinstalling the shipping

bolts.

UNPACKING AND REMOVING SHIPPING BOLTS

FEATURES AND BENEFITS

Foam Tub

Support

Carton

Base

Shipping

Bolts

Power

Cord

Shipping Bolts

Hole Cap

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 63 64

Comments to this Manuals

No comments

Kenmore 26-41262 Owner's Manual Page 8

Comments to this Manuals

Related products and manuals for Washing machines Kenmore 26-41262