Kenmore 141.17337 User Manual download pdf (Page 21)

Fuel Gauge Display Installation.

1. Open the front Doors of Cabinet. Pull out the LPG

Tank Pull-out Tray. Connect the Wire Plug "A" from

Fuel Gauge Display with the Wire Plug "B"from rear

of Tank Pull-out Tray. Unscrew 1/4" x 1/2" Pattern

Head Screw (Lower) from Rear Panel and fix Wire

Plug "A" into Wire Fastener. Install Wire Fastener to

Rear Panel. Tighten securely using the same screw.

See Fig.12a

Calibration Procedure.

1. Before installing batteries be sure the gas tank is not

mounted in the tank pull-out tray.

2. From the backside of the Side Burner Frame, unscrew

the Fuel Gauge Display Cover on the Fuel Gauge

Display Box. See Fig.12b

3. Carefully remove the battery box from the back of the

Fuel Gauge Display Box and insert two "AAA" batter

ies (provided). Be sure to follow correct polarity when

inserting batteries.

4. Return the Battery Box with electric wire into the Fuel

Gauge Display Box.

5. Screw the Fuel Gauge Display Cover onto the Fuel

Gauge Display Box.

6. During calibration the Fuel Gauge Display shows the

tank images of FULL and then EMPTY quickly.

IMPORTANT: When changing batteries be sure to

remove the gas tank from the tank pull-out tray.

Fuel Gauge Display Operating - See Fig. 12c

Press the “CHECK” button to operate Fuel Gauge Dis

play with the gas tank mounted in the Tank Pull-Out Tray.

NOTE: Tank must be positioned in tray for Fuel

Gauge Display check

1. Fuel Display: Indicates gas tank fill level.

2. Fuel Warning Display: When the gas tank fill level

is on the last row, a warning signal will sound for

approximately 3 seconds to warn you that the tank

volume is near empty.

3. Battery Warning Display: A low battery warning

light will illuminate when the battery voltage drops to

a low level. Replace the batteries.

NOTES:

1. The Fuel Gauge Display lasts for approximately 20

seconds each time you press the “CHECK” button.

After 20 seconds, the Fuel Gauge Display turns off

automatically. If you press the button a second time

within 20 seconds, the Fuel Gauge Display will be

turned off manually. If you press the button a sec

ond time after 20 seconds, the Fuel Gauge Display

will work and last for another 20 seconds.

2. The Fuel Gauge Display works only with a tank on

the Tank Pull-Out Tray. No readout will appear if a

tank is not mounted on the Tank Pull-Out Tray.

Figure 12a

CART LEG

-WHEEL SIDE

IMPORTANT: When the gas tank is removed from

the tank puil-out tray, the fuei gauge display will not

operate.

'CHECK

BUTTON

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 42 43

Comments to this Manuals

No comments

Kenmore 141.17337 User Manual Page 21

Comments to this Manuals

Related products and manuals for Food processors Kenmore 141.17337