Kenmore 141.17337 User Manual download pdf (Page 19)

Ignitor Battery Installation - See Fig. 9

1. Unscrew both Ignitor Caps located on the grill

Control Panel and remove the Contact and

Spring from each Ignitor Siot.

2. Place the manufacturer supplied AA battery

into each Ignitor Siot. Be sure to place the

pcs±i?e poife feeing fcwaid yxi. See Fig. 9

3. Place the Spring over the AA battery, then

place the Contact on top of the Spring.

Screw the Ignitor Cap back onto the grill

Control Panel.

4. Remove any protective film from outside and

inside of Grill Head.

IMPORTANT: Before use of this grill please

refer to Cleaning Exterior Stainless Steel

Surfaces found on page 27 of this Owner's

Manual.

Electrode Check - Requires an Assistant

Before placing the cooking components into your

grill, ensure that the Spark Electrode Tip is properly

positioned within each Gas Coliector Box ( a

3-1/4” wide stainless mechanism found at the front

between each set of Burners.) The easiest way to

ensure tills is to perform this Electrode Check:

1. Be sure all Control Knobs are set to "OFF"

and open the Griii Lid.

2. Have an assistant stand behind to the right of

the grill and look down at each Gas Collector

Box. NEVER put your face inside Grill Head.

3. Press the Ignitor Cap. You should hear a

"clicking” sound and your assistant should see

a small blue spark within each Gas Collector

Box. If a spark is present the Electrode Tips

are properly positioned.

4. If no spark is seen the Spark Gap shown in

Fig. 10 needs to be adjusted as foiiows:

Figure 9

• Using an adjustable wrench, loosen the Inside

Nut Just until the Gas Collector Box can be

maneuvered and turned upward.

• The gap between the Spark Electrode Tip and

Spark receiver should be approximately 3/16".

• If the gap is wider than 3/16" use a pair of long

nose pliers and gently squeeze the Gas Coliector

Box until the gap is correct.

• Return the Gas Collector Box to its original

horizontal position, secure the Inside Nut and try

the Electrode Check again.

5. If no "clicking" sound is heard check the following

common causes. If you need assistance call our

Customer Service Helpline

at 1-888-317-7642.

• Ignitor AA battery not installed property.

• Ignitor wires may be loose. Remove the AA

battery, inspect the Ignitor Junction Box found

behind the Control Panel, and connect any loose

wires.

Figure 10 - Side View Figure

GAS COLLECTOR BOX

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 42 43

Comments to this Manuals

No comments

Kenmore 141.17337 User Manual Page 19

Comments to this Manuals

Related products and manuals for Food processors Kenmore 141.17337