Kenmore 70222 Installation Guide download pdf (Page 22)

REVERSE DOOR SWING (OPTIONAL)

NOTE: Magnetized screwdriver is helpful.

Place towel on top of dryer to avoid damaging the surface.

1. Place towel on dryer

2. Remove bottom screws

Open dryer door. Remove bottom screws from dryer cabinet side

of hinges. Loosen (do not remove) top screws from dryer cabinet

side of hinges.

Lift door until top screws in dryer cabinet are in large part of

hinge slot. Pull door forward o screws. Set door (handle side

up) on top of dryer. Remove top screws from dryer cabinet.

3. Liftdooroﬀtopscrews

Remove screws at top, bottom, and side of door (4 screws) that

hold the inner and outer door together. Holding door over towel

on dryer, grasp sides of outer door and lift to separate it from

inner door. Set outer door aside.

NOTE: Do not pry apart with putty knife or screwdriver.

Do not pull on door seal or plastic door catches.

5. Remove screws from door

Remove the door catch, bezel, and plug from the inside of the

inner door by squeezing and pulling/pushing them. Place the

door catch, bezel, and plug on the sides opposite from where

they were.

Plug

Catch and bezel

6. Switch door catch, bezel, & plug

4. Remove screws from hinges

Remove screws attaching hinges to door.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

No comments

Kenmore 70222 Installation Guide Page 22