Kenmore 70222 Installation Guide Page 16
- Page / 68
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
16
B
CE
2. Connect neutral ground wire
and neutral wire
Connect neutral ground wire (E) and neutral wire (white or
center wire) (C) of power supply cord or cable under center
terminal block screw (B). Tighten screw.
3. Connect remaining wires
Place hooked ends of remaining wires under outer terminal
block screws (hooks facing right). Tighten screws.
A
E
4. Connect external ground wire
Connect a separate copper ground wire (E) from the external
ground conductor screw (A) to an adequate ground. Finally,
reinstall terminal block cover. Secure cover with hold-down
screw. Now, go to “Venting Requirements.”
1. Connect gas supply to dryer
Remove red cap from gas pipe. Using a wrench to tighten,
connect gas supply to dryer. Use pipe-joint compound
on threads of all non- ared male ttings. If exible metal
tubing is used, be sure there are no kinks.
NOTE: For LP gas connections, you must use pipe-joint
compound resistant to action of LP gas. Do not use
TEFLON
®†
tape.
A
B
Non- ared
male tting
Flared
male tting
3. Open shut-off valve
Open shut-o valve in supply line; valve is open when handle
is parallel to gas pipe. Then, test all connections by brushing
on an approved noncorrosive leak-detection solution. Bubbles
will show a leak. Correct any leaks found.
A
B
Open valve
Closed valve
A
B
D
C
2. Plan pipe fi tting connection
A combination of pipe ttings must be used to connect dryer
to existing gas line. A recommended connection is shown. Your
connection may be di erent, according to supply line type,
size, and location.
A. 3/8" exible gas connector
B. 3/8" dryer pipe
C. 3/8" to 3/8" pipe elbow
D. 3/8" pipe-to- are adapter tting
MAKE GAS CONNECTION –
U.S.A. AND CANADA
- Kenmore® 1
- DRYER SAFETY 2
- INSTALLATION REQUIREMENTS 4
- LOCATION REQUIREMENTS 5
- Steam Non-Steam 6
- ELECTRICAL REQUIREMENTS – 7
- U.S.A. ONLY (SPÉCIFICATIONS 7
- ÉLECTRIQUES – ÉTATS-UNIS 7
- SEULEMENT) 7
- ELECTRIC DRYER POWER 8
- HOOKUP – CANADA ONLY 8
- GAS DRYER POWER HOOKUP – 8
- INSTALL LEVELING LEGS 9
- 2. Screw in leveling legs 10
- POWER SUPPLY CORD CONNECTION 11
- 3. Connect ground wire 12
- 1. Remove center screw 12
- 4. Connect remaining wires 12
- 3. Connect remaining wires 13
- 2. Connect neutral wire 13
- (127 mm) 14
- 5" 14
- 1" 15
- 3½" 15
- MAKE GAS CONNECTION – 16
- U.S.A. AND CANADA 16
- Venting Requirements 17
- Plan Vent System 18
- CONNECT INLET HOSES 19
- 7. Check for leaks 20
- 6. Turn on cold water faucet 20
- 1. Level dryer 21
- 2. Adjust leveling legs 21
- REVERSE DOOR SWING (OPTIONAL) 22
- 7. Rotate outer door 23
- 8. Flip door over 23
- 9. Attach door hinges 23
- 10. Remove door strike and 23
- TROUBLESHOOTING 24
- SEGURIDAD DE LA SECADORA 25
- ADVERTENCIA 25
- REQUISITOS DE INSTALACIÓN 27
- REQUISITOS DE UBICACIÓN 28
- DIMENSIONES DE LA SECADORA 29
- REQUISITOS ELÉCTRICOS – 30
- EE.UU. SOLAMENTE 30
- CONEXIÓN ELÉCTRICA 31
- DE LA SECADORA A GAS – 31
- EE.UU. Y CANADÁ 31
- Gas natural: 32
- En los EE.UU.: 32
- En Canadá: 32
- INSTALACIÓN DE LAS PATAS 33
- NIVELADORAS 33
- PARA HACER LA CONEXIÓN 34
- ELÉCTRICA – EE.UU. SOLAMENTE 34
- 3. Conecte el hilo a tierra 35
- 1. Quite el tornillo central 36
- 2. Conecte el hilo neutro 36
- CONEXIÓN POR CABLE DIRECTO 37
- 3. Abra la válvula de cierre 40
- CONEXIÓN DE LAS MANGUERAS 42
- DE ENTRADA 42
- (101 mm) 43
- /4" 43
- (768 mm) 43
- 2. Traslade la secadora 44
- 1. Nivele la secadora 44
- LISTA DE CONTROL DE LA 45
- INSTALACIÓN TERMINADA 45
- DE LA PUERTA (OPCIONAL) 46
- 7. Gire la puerta exterior 47
- 8. Dé vuelta la puerta 47
- SOLUCIÓN DE PROBLEMAS 48
- SÉCURITÉ DE LA SÉCHEUSE 49
- EXIGENCES D’INSTALLATION 51
- EXIGENCES D’EMPLACEMENT 52
- DIMENSIONS DE LA SÉCHEUSE 53
- POUR L’INSTALLATION 53
- RACCORDEMENT DE LA SÉCHEUSE 54
- RACCORDEMENT ÉLECTRIQUE 55
- DE LA SÉCHEUSE À GAZ – 55
- ÉTATS-UNIS ET CANADA 55
- 2. Plani er la connexion 57
- L’ÉVACUATION 58
- Brides de serrage : 59
- RACCORDEMENT DES 60
- TUYAUX D’ALIMENTATION 60
- 3. Serrer les raccords 61
- 7. Recherche de fuites 61
- 2. Placer la sécheuse 62
- ACHEVER L’INSTALLATION LISTE 63
- DE VÉRIFICATION 63
- INVERSION DU SENS D’OUVERTURE 64
- DE LA PORTE (FACULTATIF) 64
- 8. Retourner la porte 65
- 13. Contrôler l’alignement 66
- W10850306A 68
Related products and manuals for Electric laundry dryers Kenmore 70222
(68 pages)
(40 pages)© 2020, manymanuals.com. All rights reserved. | 0.704 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals