Kenmore 17921 User Manual download pdf (Page 7)

SETTING UP YOUR MACHINE

1. Install your Kenrnore sewing machine in a

Kenmore cabinet, case or set the machine

on. a sturdy flat surface.

2. Your Kenmore sewing machine has been

thoroughly oiled at the factory. Be sure to

wipe off the needle plate area and bed

plate carefully before sewing a garment.

It is wise to practice on a scrap of fabric

so any surplus oil is absorbed.

3. FOOT CONTROL

Your machine is supplied with an

electronic foot control which enables you

to sew very slowly. Even at low speed you

have extra power for the needle to

penetrate through several thicknesses of

fabric. Faster speeds are also easily

controlled.

1. Pull out the foot control from its

storage position under the free arm.

(Fig. 1)

2. Slide pedal lock knob to the right and

the foot pedal will pop up to its

operating position. Push foot control

plug into the cord receptacle on the

foot control. (Fig. 2)

3. Push machine plug into the cord

receptacle at the rear side of the

machine. Then connect power-line

plug into any 110-120 volt A.C. wall

outlet. (Fig. 2)

4. LIGHT/POWER SWITCH

Your machine will not operate unless the

light/power switch is turned on. This

same switch controls the machine power,

sewing light and indicator lights on the

stitch indicator panel and electronic

needle control. If you are interrupted or

stop sewing, turn off the switch.

1 2 3 4 5 6 7 8 9 10 11 12 ... 64 65

Comments to this Manuals

No comments