Kenmore 59921 Installation Guide download pdf (Page 9)

CleaningOperation Installation Service Parts

INSTALL THE HOOD (HORIZONTALLY DUCTED HOODS ONLY)

1. DO NOT REMOVE the protective plastic

film covering the decorative flues at this

time.

2. Make sure there will be adequate

clearance between top of hood and

lower flue mounting bracket for ductwork.

Elbow must be located below lower flue

mounting bracket.

3. Align the hood and center it above the

hood mounting bracket. Gently lower the

hood until it securely engages the bracket.

4. If a framing member is not present: With

the hood hanging in place, drill through

both holes located in the inside lower back

of hood using a 5/16” drill bit. Insert the

included drywall anchors into the drilled

holes(oneforeachhole).

5. Install (2) washers and (2) #8 x 1½”

mounting screws through the back of the

hood and into the drywall anchors. Verify

that the hood is centered and leveled.

Tighten all screws completely.

6. Measure and

install 6” round

metal ductwork

to roof cap or

wall cap and 90

elbow over duct

collar on hood.

Use duct tape to

make all joints

secure and air

tight.

7. Plug hood power

cord into the

outlet.

UPPER

FLUE

UPPER FLUE MOUNTING

BRACKET - FRONT VIEW

8. Remove the upper

flue from inside

the lower flue.

Install the lower

flue bracket to the

lower flue using

(2)fluebracket

screws(#8x

3/8”).Ensure

that the bracket

is positioned inside of the lower flue flanges - with the

slots on top. Carefully replace the upper flue inside the

lower flue. Remove protective plastic film covering the

lower flue only.

9. Carefully place both flues into the recessed area of

hood top.

8¼”

MAX.

LOWER FLUE

MOUNTING

BRACKET

HOLE LOCATIONS

Ø5/16”

TYP.

MOTOR/

BLOWER

ASSEMBLY

SIDE VIEW

INSIDE

BACK

HOOD

6” ROUND

ELBOW

LOWER FLUE

MOUNTING BRACKET

LOWER FLUE

10. Slide the upper

flue upward until it

is aligned with its

upper flue mounting

bracket. The bracket

should be inside

the flue. Secure the

upper flue to the

upper flue mounting

bracketusing(2)#8

x 3/8” mounting

screws.

11. Remove protective

plastic film covering

the upper flue and

the hood.

12. Reinstall grease filter

by aligning rear filter tab with slot in the hood, push in

the metal latch tab, push filter into position and release.

Make sure filter is securely engaged after installation.

WarrantySafety

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments

Kenmore 59921 Installation Guide Page 9

Comments to this Manuals

Related products and manuals for Cooker hoods Kenmore 59921