Kenmore 59921 Installation Guide download pdf (Page 8)

1. Place range hood body on its back, with controls

facing up. Place cardboard under hood to protect

countertop or table finish.

2. Position the curved plate glass over the range hood

body as shown.

3. Installrubberbushingsintoall(4)holesoftheglass.

4. Placeaplasticdecorative washeronto(4) M4x

1-in. flathead mounting screw.

5. Align holes in glass with holes in the range hood

body.Installandfasten(4)black,flat-headscrews

with decorative washers through rubber bushings

and into the range hood body.

6. Hand-tighten screws, but do not overtighten.

INSTALL CURVED GLASS PLATE

1. Remove the grease filter by pushing in the metal

latch tab. Pull filter out to remove.

2. Install(2)TypeB10,40-Wattmaximum,incandes-

centcandelabrabulbs(included).

Note: When replacing bulbs, remove the non-ducted

filter (if installed) to ease lamp installation.

INSTALL BULBS

1. Install damper/duct connector to top of hood using

(4)#8x3/8”panheadmountingscrews.

Note: Damper flaps must be removed and discarded

for non-ducted installations.

INSTALL DUCT CONNECTOR

(4)

M4 X 1-IN.

SCREWS

(BLACK)

(4)

BUSHINGS

(4)

#8X3/8”

PAN HEAD

SCREWS

DAMPER

FLAPS

DAMPER/DUCT CONNECTOR

NON-DUCT

FILTER

GREASE

FILTER

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comments to this Manuals

No comments

Kenmore 59921 Installation Guide Page 8

Comments to this Manuals

Related products and manuals for Cooker hoods Kenmore 59921