Kenmore 59921 Installation Guide download pdf (Page 7)

INSTALL UPPER FLUE MOUNTING BRACKET

WarrantySafety CleaningOperation Installation Service Parts

1. If a framing member is not present, drill two

⁄16” diameter holes where shown. Insert dry-

wall anchors into the holes.

2. Center the bracket over the hood location and

flush with the ceiling. Make sure that the slots

of the upper flue bracket are at the bottom.

Secure the upper flue brackettothewallusing(2)

#8x1½” mounting screws.

3. Tighten the screws completely. Make sure that

the bracket is tight against the wall.

Flush with

the ceiling

Center of

installation

Upper flue mounting

bracket slots

5¾”

⁄ 8”

Recommended

distance

between

screw

holes

Ceiling

Ø 5/16”

TYP.

Ceiling

Center of installation

1. GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event

of an electrical short circuit, grounding reduces

the risk of electric shock by providing an escape

wire for the electric current. This appliance

is equipped with a cord having a grounding

wire with a grounding plug. The plug must be

plugged into an outlet that is properly installed

and grounded.

2. Position the electrical outlet within the space

covered by the decorative flue and where it

will not interfere with the round duct. Make sure

the outlet does not interfere with the mounting

bracket fastening area, ductwork, or where the

decorative flue touches the wall.

4”

20-3/4”

13”

LOCATE

ELECTRICAL

OUTLET

WITHIN

THESE

AREAS.

(Verify

location

will not

interfere

with duct,

mounting

brackets,

and ﬂue.)

BACK OF

HOOD

10”

INSTALL THE WIRING

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments

Kenmore 59921 Installation Guide Page 7

Comments to this Manuals

Related products and manuals for Cooker hoods Kenmore 59921