Kenmore 59921 Installation Guide download pdf (Page 10)

6” ROUND

DUCT

(VERTICAL

DUCTING)

5. Measure and cut metal ductwork. Set ductwork

aside.

6. Plug hood power cord into the outlet.

7. Remove the upper flue from inside the lower flue.

Install the lower flue bracket to the lower flue using

(2) flue bracket screws (#8 x 3/8”). Ensure that

the bracket is positioned inside of the lower flue

flanges - with the slots on top. Carefully replace the

upper flue inside the lower flue. Remove protective

plastic film covering the lower flue only.

8. Place both flues into the recessed area of hood top.

9. Carefully rotate bottom of flue assembly out and

slide metal duct section into flue assembly.

10. Connect duct section to duct connector and duct

rough-in. Use duct tape to make sure all joints are

secure and air tight.

11. Slide the upper flue upward until it is aligned with

its upper flue mounting bracket. The bracket should

be inside the flue. Secure the upper flue to the

upperfluemountingbracketusing(2)#8x3/8”

mounting screws.

12. Remove protective plastic film covering the upper

flue and the hood.

13. Reinstall grease filter by aligning rear filter tab with

slot in the hood, push in the metal latch tab, push

filter into position and release. Make sure filter is

securely engaged after installation.

3. If a framing member is not present: With the hood

hanging in place, drill through both holes located

in the inside lower back of hood using a 5/16” drill

bit. Insert the included drywall anchors into the

drilledholes(oneforeachhole).

4. Install (2) washers and (2) #8 x 1½” mounting

screws through the back of the hood and into the

drywall anchors. Verify that the hood is centered

and leveled. Tighten all screws completely.

1. DO NOT REMOVE the protective plastic film

covering the decorative flues at this time.

2. Align the hood and center it above the hood

mounting bracket. Gently lower the hood until it

securely engages the bracket.

INSTALL THE HOOD (VERTICALLY DUCTED HOODS ONLY)

HOLE LOCATIONS

Ø5/16”

TYP.

MOTOR/

BLOWER

ASSEMBLY

SIDE VIEW

INSIDE

BACK

HOOD

UPPER FLUE

UPPER FLUE MOUNTING

BRACKET - FRONT VIEW

LOWER FLUE

MOUNTING BRACKET

LOWER FLUE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comments to this Manuals

No comments

Kenmore 59921 Installation Guide Page 10

Comments to this Manuals

Related products and manuals for Cooker hoods Kenmore 59921