Kenmore 75232 Installation Guide download pdf (Page 19)

2. Connect vent to exhaust hood

Vent must t over the exhaust hood. Secure vent to exhaust

hood with 4" (102 mm) clamp. Run vent to dryer location using

straightest path possible. Avoid 90° turns. Use clamps to seal

all joints. Do not use duct tape, screws, or other fastening

devices that extend into interior of vent to secure vent,

because they can catch lint.

INSTALL VENT SYSTEM

12" min.

(305 mm)

12" min.

(305 mm)

1. Install exhaust hood

Install exhaust hood and use caulking compound to seal

exterior wall opening around exhaust hood.

CONNECT INLET HOSES

For non-steam models, skip to “Connect Vent.”

The dryer must be connected to the cold water faucet using

the new inlet hoses. Do not use old hoses.

Turn cold water faucet o and remove washer inlet hose.

Remove old rubber washer from inlet hose and replace

with new rubber washer.

1. Turn cold water o; remove and replace

rubber washer

3. Tighten couplings

Using pliers, tighten the couplings with additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

2. Attach short hose and “Y” connector

Attach 2 ft (0.6 m) inlet hose to cold water faucet. Screw on

coupling by hand until it is seated on faucet. Then attach “Y”

connector to one end of the 2 ft (0.6 m) inlet hose. Screw on

coupling by hand until it is seated on connector.

4. Attach long hose to “Y” connector

and tighten couplings

Attach one end of dryer 5 ft (1.5 m) inlet hose to the “Y”

connector. Attach washer cold inlet hose to other side of “Y”

connector. Screw on coupling by hand until it is seated on

connector. Using pliers, tighten the couplings an additional

two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 67 68

No comments

Kenmore 75232 Installation Guide Page 19