Kenmore 75232 Installation Guide download pdf (Page 11)

1. Attach power supply cord strain relief

Remove the screws from a 3/4" (19 mm) UL Listed strain relief.

Put the tabs of the two clamp sections (C) into the hole below

the terminal block opening (B) so that one tab is pointing up

(A) and the other is pointing down (D), and hold in place.

Tighten strain relief screws just enough to hold the two clamp

sections (C) together.

Power Supply Cord Strain Relief

POWER SUPPLY CORD CONNECTION

Put power supply cord through the strain relief. Be sure that

the wire insulation on the power supply cord is inside the strain

relief. The strain relief should have a tight t with the dryer

cabinet and be in a horizontal position. Do not further tighten

strain relief screws at this point.

2. Attach power supply cord to strain relief

4-wire Power Supply Cord Connection

IMPORTANT: A 4-wire connection is required for mobile homes

and where local codes do not permit the use of 3-wire connections.

Power supply cord 4-wire receptacle

(NEMA Type 14-30R):

Go to “4-wire Power Supply Cord

Connection”.

Power supply cord 3-wire receptacle

(NEMA Type 10-30R):

Go to “3-wire Power Supply Cord

Connection”.

If your outlet looks like this:

4-wire receptacle (NEMA

type 14-30R)

4-prong plug

Spade terminals with

upturned ends

Ring terminals

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 67 68

No comments

Kenmore 75232 Installation Guide Page 11