Kenmore Elite 36'' Italian-Design Wall-Mounted Range Hood Warranty download pdf (Page 7)

INSTALL THE DUCTWORK

NOTE: To reduce the risk of re, use only metal

ductwork.

1. Decide where the ductwork will run between the

hood and the outside.

2. A straight, short duct run will allow the hood to

perform most eciently.

3. Long duct runs, elbows, and transitions will

reduce the performance of the hood. Use as

few of them as possible. Larger ducting may be

required for best performance with longer duct

runs.

4. Install a roof or wall cap. Connect round metal

ductwork to cap and work back towards hood

location. Use duct tape to seal the joints between

ductwork sections.

INSTALL MOUNTING BRACKET

1. Construct wood wall framing that is ush with

interior surface of wall studs.

Make sure:

a) the framing is centered over installation loca-

tion.

b) the height of the framing will allow the

mounting bracket to be secured to the fram-

ing within the dimensions shown.

2. After wall surface is nished, secure mounting

bracket to framing using dimensions shown.

FRAMING BEHIND

DRYWALL

38-1/16”= bottom of hood 24” above cooktop

44-1/16”= bottom of hood 30” above cooktop

38-1/16” to 44-

1/16” above co-

oktop

INSTALL THE HOOD

1. Hang the hood from the bracket through the

rectangular cut-out on the back of the hood.

Cut-out is larger than the bracket to allow for

horizontal adjustment.

The bottom of the hood should be 24” to 30”

above the cooking surface.

2. Attach (2) hood height / angle adjustment

screws (3,9 x 9,5mm) to hood bracket. Use these

screws to level the hood.

3. Secure the hood with mounting screws (4,8 x

3,8mm). Use drywall anchors, provided, if wall

studs or framing are not available.

Warranty Safety Operation Cleaning Installation Service Parts

ROOF

CAP

ROUND

DUCT

DECORA-

TIVE FLUE

HOOD

WALL

CAP

ROUND

ELBOW

24” TO 30”

ABOVE COO-

KING SURFACE

6”

ADAP-

TER

MOUNTING

SCREWS

RECTANGU-

LAR CUTOUT

WALL

FRAMING

mounting

bracket

MOUNTING

SCREWS

HOOD

HEIGHT/

ANGLE

ADJUSTMENT

SCREWS

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments

Kenmore Elite 36'' Italian-Design Wall-Mounted Range Hood Warranty Page 7

Comments to this Manuals

Related products and manuals for Cooker hoods Kenmore Elite 36'' Italian-Design Wall-Mounted Range Hood