Kenmore Elite 36'' Italian-Design Wall-Mounted Range Hood Warranty download pdf (Page 10)

FLUE MOUNTING

BRACKET

MOUNTING

SCREWS

(3,9x6mm)

MOUNTING

SCREWS

(4,8x38mm)

CONNECT DUCTWORK (Non-ducted conguration only)

1. Adjust the width of the ue mounting bracket

assembly to equal the inside width of decorative

ue. Insert and tighten mounting screws (3,9 x 6

mm) to hold bracket width.

2. Use mounting screws (4,8 x 38 mm) and wall

anchors to secure ue mounting bracket assem-

bly to the ceiling as shown.

3. Measure the distance from the top of the hood

outlet to the ceiling - and add 6 inches.

4. Cut a piece of 5” round exible metallic duct

(not included) to the length determined in Step

3. Attach ange to bottom of exible duct and

secure with duct tape.

5. Attach top of exible duct to air bae and

secure with duct tape.

6. Connect the ange to the hood outlet.

7. Turn upper ue section upside down so air vents

are at the top. Slide upper ue section into lower

ue section.

8. Set ue assembly on hood, with top tilted away

from wall. Align (4) holes in bae with (4) holes

in top ue section.

9. Attach bae to upper ue section with (4)

screws (3,4 x 15 mm Flat Head) (included). Use a

short screwdriver.

10. Extend the upper ue section to the ceiling and

secure to upper bracket with (2) mounting screws

(3,9 x 9,5 mm).

UPPER BRACKET

DUCT TAPE

5” ROUND

FLEXIBLE

METAL

DUCT

UPPER

FLUE

SECTION

AIR VENTS

LOWER

FLUE

SECTION

MEASURE

& ADD 6

INCHES

AIR BAFFLE

DUCT

TAPE

FLANGE

HOOD

OUTLET

WALL

AN-

CHORS

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comments to this Manuals

No comments

Kenmore Elite 36'' Italian-Design Wall-Mounted Range Hood Warranty Page 10

Comments to this Manuals

Related products and manuals for Cooker hoods Kenmore Elite 36'' Italian-Design Wall-Mounted Range Hood