Kenmore 7.0 cu. ft. Electric Dryer w/ Auto Dry - White Installation Guide download pdf (Page 7)

Screw in leveling legs

Using a wrench and tape measure, screw legs into leg holes until

bottom of foot is approximately 1/2" (13 mm) (to match height of 3.6

cu. ft. capacity washer) or 1½" (38 mm) (to match height of 3.8 cu. ft.

capacity washer) from bottom of dryer.

Now stand the dryer on its legs. Slide the dryer until it is close to its

nal location. Leave enough room for electrical connection and to

connect the exhaust vent.

INSTALL LEVELING LEGS

Prepare dryer for leveling legs

To avoid damaging oor, use a large at piece of cardboard from

dryer carton; place under entire back edge of dryer. Firmly grasp

dryer body (not console panel) and gently lay dryer down on

cardboard.

ELECTRICAL CONNECTION

Power Supply Cord

Electrical Connection Options

1. Choose electrical connection type

Power supply cord 4-wire receptacle

(NEMA Type 14-30R):

Go to “Power Supply Cord Connection.”

3-wire direct connection:

Go to “Direct Wire Connection.”

4-wire direct connection:

Go to “Direct Wire Connection.”

Power supply cord 3-wire receptacle

(NEMA Type 10-30R):

Go to “Power Supply Cord Connection.”

NOTE: If local codes do not permit connection of a cabinet-

ground conductor to neutral wire, go to “Optional 3-wire

connection.” This connection may be used with either a power

supply cord or a direct wire connection.

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

No comments

Kenmore 7.0 cu. ft. Electric Dryer w/ Auto Dry - White Installation Guide Page 7