Kenmore 7.0 cu. ft. Electric Dryer w/ Auto Dry - White Installation Guide download pdf (Page 16)

LEVEL DRYER

Level Dryer

Not Level LEVEL Not Level

Check levelness of dryer from side to side. Repeat from front to back.

NOTE: The dryer must be level for the moisture sensing system to operate

correctly.

Move dryer to nal location

Move dryer to nal location. Avoid crushing or kinking vent. After dryer

is in place, remove cardboard from under the dryer.

Adjust leveling legs

If dryer is not level or the same height as the washer, prop up using

a wood block. Use wrench to adjust legs up or down, and check again

for levelness. Once legs are level, make sure all four legs are snug

against the oor before tightening them.

COMPLETE INSTALLATION

CHECKLIST

Check that all parts are now installed. If there is an extra part,

go back through steps to see what was skipped.

Check that you have all of your tools.

Dispose of/recycle all packaging materials.

Check dryer’s nal location. Be sure vent is not crushed or kinked.

Check that dryer is level. See “Level Dryer.”

Remove lm on console and any tape remaining on dryer.

Wipe dryer drum interior thoroughly with a damp cloth to remove

any dust.

Read “Dryer Use” in your “Use and Care Guide.”

Set the dryer on a full heat cycle (not an air cycle) for 20 minutes

and start the dryer.

If the dryer will not start, check the following:

■ Controls are set in a running or “On” position.

■ Start button has been pushed rmly.

■ Dryer is plugged into an outlet and/or electrical supply is on.

■ Household fuse is intact and tight, or circuit breaker has not

tripped.

■ Dryer door is closed.

When the dryer has been running for 5 minutes, open the dryer door

and feel for heat. If you feel heat, cancel cycle and close the door.

If you do not feel heat, turn o dryer, and check the following:

■ There may be 2 household fuses or circuit breakers for the dryer.

Check that both fuses are intact and tight, or that both circuit

breakers have not tripped. If there is still no heat, contact a

qualied technician.

NOTE: You may notice an odor when the dryer is rst heated. This odor is

common when the heating element is rst used. The odor will go away.

Place Level Here Place Level Here

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Comments to this Manuals

No comments

Kenmore 7.0 cu. ft. Electric Dryer w/ Auto Dry - White Installation Guide Page 16

Comments to this Manuals

Related products and manuals for Washer dryers Kenmore 7.0 cu. ft. Electric Dryer w/ Auto Dry - White