Kenmore Elite 30'' Double-Oven Slide-In Electric Range w/ Convection - Black Installation Guide download pdf (Page 10)

30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

Leg

Leveler

Raise

Lower

Range Installation

Important Note: Door removal is not a requirement

for installation of the range, but is an added

convenience.

Refer to the Use

and Care Guide for

oven door removal

instructions.

Standard Installation

5.1

The range cooktop overlaps the countertop

at the sides and the range rests on the ﬂ oor. The

cooktop is 31½" (81 cm) wide.

5.2

Install base cabinets 30" (76.2 cm) apart.

Make sure they are plumb and level before

attaching cooktop. Shave raised countertop edge

to clear 31½" (81 cm) wide range top rim.

5.3

Install cabinet doors 31" (78.7 cm) min. apart

so it will not interfere with range door opening.

5.4

Cutout countertop exactly as shown on page 4.

5.5

Make sure the four leveling legs (front and

rear) are setup higher than the height of the

cabinet (shown on page 5).

5.6

Install the anti-tip bracket

at this point before placing the range at its ﬁ nal

position. Follow the installation instructions on page

12 or on the anti-tip bracket template supplied

with the range.

5.7

To provide an optimum installation, the top

surface of the countertop must be level and ﬂ at

(lie on the same plane) around the 3 sides that are

adjacent to range cooktop. Proper adjustments to

make the top ﬂ at should be made or gaps between

the countertop and the range cooktop may occur.

5.8

To reduce the risk of

damaging your appliance, do not handle or

manipulate it by the ceramic glass. Manipulate

with care.

5.9

Position range in front of the cabinet

opening.

5.10

Make sure that the glass which overhangs the

countertop clears the countertop. If necessary, raise

the unit by lowering the leveling legs.

5.11

Level the range (see section 6). The ﬂ oor

where the range is to be installed must be level.

Follow the instructions under "Leveling the Range-

Models Equipped with Leveling Legs".

5.12

Slide the range into the cutout opening.

Leveling the range

Models Equipped with Leveling Legs

Level the range and set cooktop height before

installation in the cut-out opening.

1. Install an oven rack in the center of the oven.

2. Place a level on the rack (see Figure 9). Take

2 readings with the level placed diagonally

in one direction and then the other. Level the

range, if necessary, by adjusting the 4 leg

levelers with a wrench (see Figure 10).

3. Taking care to not damage the countertop, slide

range into cutout opening and double check for

levelness.

Figure 9

Figure 8

Figure 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comments to this Manuals

No comments

Kenmore Elite 30'' Double-Oven Slide-In Electric Range w/ Convection - Black Installation Guide Page 10

Comments to this Manuals

Related products and manuals for Ovens Kenmore Elite 30'' Double-Oven Slide-In Electric Range w/ Convection - Black