Kenmore Elite 30'' Double-Oven Slide-In Electric Range w/ Convection - Black Installation Guide download pdf (Page 6)

30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

Serial Plate

Location

You will ﬁ nd the model

and serial number printed

on the serial plate. The

serial plate is located as

shown.

Remember to record the

serial number for future

reference.

Power Supply Cord Kit

The user is responsible for connecting the power

supply cord to the connection block located behind

the back panel access cover.

This appliance may be connected by means of

permanent "hard wiring"; ﬂ exible armored or

nonmetallic shielded copper cable (when local

code allow it) or by means of a power supply cord

kit.

NOTE: Electric Slide-in Range is shipped from

factory with 1 1/8" (2.9 cm) dia. hole as shown on

ﬁ gure 4. If a larger hole is required, punch out the

knockout.

Risk of ﬁ re or electrical shock

exists if an incorrect size range cord kit is used,

the Installation Instructions are not followed, or

the strain relief bracket is discarded.

For mobile homes, new installations or recreational

vehicles, use only a power supply kit designed for a

range at 125V/250V 50A recommended (minimum

40A). Cord must have either 3 (when local code

permits grounding through neutral) or 4 conductors.

Terminal on end of wires must be either closed loop

or open spade lug with upturned ends. Cord must

have strain-relief clamp.

Do not loosen the nuts which

secure the factory-installed range wiring to

terminal block while connecting range. Electrical

failure or loss of electrical connection may occur.

This appliance is manufactured

with the frame grounded by connection of a

grounding strap between the neutral power

supply terminal and the frame. If used in USA,

in a new branch circuit installation (1996 NEC),

mobile home or recreational vehicule, where

local code do not permit grounding through

neutral (white) wire or in Canada; remove the

grounding strap from the frame and cut the

other end, near the neutral terminal. Connect

the appliance in usual manner.

Figure 2

Figure 1

Electrical Shock Hazard

• Electrical ground is required on this appliance.

• Do not connect to the electrical supply until

appliance is permanently grounded.

• Disconnect power to the circuit breaker or fuse

box before making the electrical connection.

• This appliance must be connected to a

grounded, metallic, permanent wiring system,

or a grounding connector should be connected

to the grounding terminal or wire lead on the

appliance.

Failure to do any of the above could result in a

ﬁ re, personal injury or electrical shock.

Access to Terminal Block &

Grounding Strap

Open

terminal

cover door

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Kenmore Elite 30'' Double-Oven Slide-In Electric Range w/ Convection - Black Installation Guide Page 6

Comments to this Manuals

Related products and manuals for Ovens Kenmore Elite 30'' Double-Oven Slide-In Electric Range w/ Convection - Black