Kenmore 141.173373 User Manual download pdf (Page 16)

Installing The Grill Head

Figure 6a (LP gas model only)

1. Now that you've assembled the grill cart you

can install the pre-assembled Grill Head. See

Figure 6a or 6b. If you haven't already done

so, we suggest you open the Grill Lid and

remove the packed components. Even with the

components removed, this next step requires 2

people.

BE CAREFUL NOT TO PINCH FINGERS

WHEN LOWERING HEAD ONTO CART

2. For LP Gas grills:

With an assistant, lift and position the Grill

Head onto the grill cart. Place the Side Burner

Gas Valve Assembly through the ^ot in side of

Grill Head as illustrated in Figure 6a. Align the

4 holes of the Bowl Side Panel to the

threaded holes on the Cart Leg Bracket.

Thread the Electric Wire into the Wire Fastener.

Secure Wire Fastenerto Right Rear Bowl location on

Grill Head using 1 of the 1/4"x1/2" Pattern Head

Screw. Finish securing Grill Head to Cart using 3 of

the 1/4"x1/2" Pattern Head Screws provided.

3. For Natural Gas grills:

With an assistant, lift and position the Grill

Head onto the grill cart. Place the Side Burner

Gas Valve Assembly and Electric Wire through

the slot in side of Grill Head as illustrated in

Figure 6b. Align the 4 holes of the Bowl Side

Panel to the threaded holes on the Cart Leg

Bracket. Secure firmly by using 4 of the 1/4"x

1/2" Pattern Head Screws provided.

jlnstalling Lighting Stick

Attach the Lighting Stick to the Left Bo\a^

Support Bracket as shown in Figure 7.

Align the hole at the end of Lighting Stick

Wire with the threaded hole on the Left Bow^

Support Bracket. Tighten securely using the

M4x8mm Pattern Head Screw.

Figure 6b (Natural gas model only)

Figure 7

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 42 43

No comments

Kenmore 141.173373 User Manual Page 16