Kenmore 73029 Owner's Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
16
17
REFRIGERATOR LEVELING
& DOOR ADJUSTMENT
The refrigerator must be level in order to maintain optimal
performance and desirable front appearance.
(If the oor beneath the refrigerator is uneven, the freezer
and refrigerator doors look unbalanced.)
Leveling Refrigerator
1.
Fully open the freezer drawer and remove the freezer
drawer basket to gain access to the lower toe guard
fasteners.
2.
Remove the lower toe guard using a phillips
screwdriver.
NOTE:
Put screws in safe location so they are not lost.
3.
Using the wrench provided, turn the leveling leg
clockwise to lower and counterclockwise to raise the
front corners of the refrigerator.
4.
Install lower toe guard/grille using a phillips
screwdriver.
5.
Install freezer drawer basket, then open and close the
freezer drawer several times to make sure operation is
smooth without hindrance.
Adjusting a refrigerator door
If the height of the refrigerator doors is uneven, turn the
screw nut on the middle hinge to adjust the refrigerator door.
1.
To raise a refrigerator door turn the screw
counterclockwise.
2.
To lower a refrigerator door turn the screw clockwise.
Adjusting the freezer drawer
If the freezer drawer is higher on one side than the other
(not even):
1.
Loosen the four side screws on the side where
adjustment is needed.
2.
Move the Stopper from ‘left picture position’ to ‘right
picture position.
3.
Adjust the leveling by rotating the Position Knob.
(Pull and rotate the Position Knob)
4.
After adjusting the leveling, tighten the four side screws.
RaiseLower
REFRIGERATOR INSTALLATION
Adjusting the freezer drawer
If the freezer drawer is higher on one side than the other
(not even):
1. Loosen the four side screws on the side where adjustment is needed.
2. Move the Stopper from ‘left picture position’ to ‘right picture position’.
3. Adjust the leveling by rotating the Position Knob.
(Pull and rotate the Position Knob)
4. After adjusting the leveling, tighten the four side screws.
1
3
2
1
2
3
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Comments to this Manuals

No comments