Kenmore 73029 Owner's Manual download pdf (Page 10)

REFRIGERATOR INSTALLATION

PRIOR TO USE

Clean your refrigerator thoroughly and wipe o all

dust that accumulated during shipping.

Install accessories such as ice cube bin, drawers,

shelves, etc., in their proper places. They are packed

together to prevent possible damage during shipment.

Allow your refrigerator to run for at least two to three

hours before putting food in it. Check the ow of

cold air in the freezer compartment to ensure proper

cooling. Your refrigerator is now ready for use.

INSTALLATION

The refrigerator should always be plugged into its own

individual properly grounded electrical outlet rated for

115 Volts, 60 Hz, AC only, and fused at 15 or 20 amperes.

This provides the best performance and also prevents

overloading house wiring circuits which could cause a re

hazard from overheated wires. It is recommended that a

separate circuit serving only this appliance be provided.

WARNING

Shock Hazard:

To reduce the risk of electric shock, do not install the

refrigerator in a wet or damp area.

INSTALLATION (continued)

To avoid noise and vibration, the unit must be leveled

and installed on a solidly constructed oor. If required,

adjust the leveling legs to compensate for unevenness

of the oor. The front should be slightly higher than the

rear to aid in door closing. Leveling legs can be turned

easily by tipping the cabinet slightly. Turn the leveling

legs to the left to raise the unit or to the right to lower

it. (See Leveling and door AlIgnment.)

NOTE:

Installing on carpeting, soft tile surfaces,

a platform or weakly supported structure is not

recommended.

Install this appliance in an area where the temperature

is between 55°F (13°C) and 110°F (43°C). If the

temperature around the appliance is too low or high,

cooling ability may be adversely aected.

Select a place where a water supply can be easily

connected for the automatic icemaker.

NOTE:

The water pressure must be from 30 to 125 psi

or 207-862 kPa or 2.1-8.8 kgf/cm². If the refrigerator

is installed in an area with low water pressure below

30 psi, you can install a booster pump to compensate

for the low pressure.

Too small of a distance from adjacent items may result

in lowered freezing capability and increased electricity

consumption charges. Allow at least 2 inch (5 cm)

between the back of the refrigerator and the wall.

2" (5 cm)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Comments to this Manuals

No comments

Kenmore 73029 Owner's Manual Page 10

Comments to this Manuals

Related products and manuals for Fridges Kenmore 73029