Kenmore 65212 Installation Guide download pdf (Page 15)

Place hooked ends of remaining direct wire cable wires

under outer terminal block screws (hooks facing right).

Squeeze hooked ends together and tighten screws. Finally,

reinstall terminal block cover. Secure cover with hold-down

screw. Now, go to “Venting Requirements.”

5. Connect remaining wires

3-wire Direct Wire Connection

Use where local codes permit connecting cabinet-ground

conductor to neutral wire.

2. Remove center screw

Remove center terminal block screw (B).

Direct wire cable must have 5 ft. (1.52 m) of extra length so

dryer may be moved if needed.

Strip 3

" (89 mm) of outer covering from end of cable. Strip

insulation back 1" (25 mm). If using 3-wire cable with ground

wire, cut bare wire even with outer covering. Shape wire ends

into hooks.

(25 mm)

3½"

(89 mm)

1. Prepare your 3-wire cable

for direct connection

4. Connect remaining wires

Place hooked ends of remaining direct wire cable wires under

outer terminal block screws (hooks facing right). Squeeze

hooked ends together and tighten screws. Finally, reinstall

terminal block cover. Secure cover with hold-down screw.

Now, go to “Venting Requirements.”

Place hooked end of neutral wire (white

or center) (C) of direct wire cable under

center terminal block screw (B). Squeeze

hooked end together. Tighten screw.

3. Connect neutral wire

1. Prepare to connect neutral

ground wire and neutral wire

Remove center terminal block screw (B). Remove neutral ground

wire (E) from external ground conductor screw (A).

Optional 3-wire Connection

with External Grounding

You must verify with a qualified electrician that this

grounding method is acceptable before connecting.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 67 68

No comments

Kenmore 65212 Installation Guide Page 15