Kenmore 65212 Installation Guide download pdf (Page 14)

Put direct wire cable through the strain relief. The strain

relief should have a tight  t with the dryer cabinet and be

in a horizontal position. Tighten strain relief screw against

the direct wire cable.

2. Attach direct wire cable to strain relief

3-wire direct connection:

Go to “3-wire Direct Connection”.

4-wire direct connection:

Go to “4-wire Direct Connection”

on this page.

If your wiring looks like this:

4-wire Direct Wire Connection

IMPORTANT: A 4-wire connection is required for mobile homes

and where local codes do not permit 3-wire connections.

Direct wire cable must have 5 ft. (1.52 m) of extra length

so dryer may be moved if needed.

Strip 5" (127 mm) of outer covering from end of cable,

leaving bare ground wire at 5" (127 mm). Cut 1

" (38 mm)

from remaining 3 wires. Strip insulation back 1" (25 mm).

Shape ends of wires into hooks.

1. Prepare your 4-wire cable

for direct connection

4. Connect ground wire

Connect ground wire (green or bare) (F) of direct wire cable

to external ground conductor screw (A). Tighten screw.

E C

3. Connect neutral ground wire

and neutral wire

Connect neutral ground wire (E) and place

hooked end (hook facing right) of neutral

wire (white or center wire) (C) of direct wire

cable under center screw of terminal block

(B). Squeeze hooked ends together and

tighten screw.

2. Prepare to connect neutral

ground wire and neutral wire

Remove center terminal block screw (B). Remove neutral

ground wire (E) from external ground conductor screw (A).

(25 mm)

⁄

(89 mm)

(127 mm)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

Comments to this Manuals

No comments

Kenmore 65212 Installation Guide Page 14

Comments to this Manuals

Related products and manuals for Electric laundry dryers Kenmore 65212