Kenmore 51737 Owner's Manual download pdf (Page 33)

CONNECTING THE WATER LINE

8. FLUSH OUT THE TUBING

Turn the main water supply on and

 ush out the tubing until the water

is clear.

Shut the water o at the water

valve after about one quart of

water has been  ushed through the

tubing.

9. CONNECT THE TUBING TO THE

REFRIGERATOR

NOTE: Before making the connection to the

refrigerator, be sure that the refrigerator power cord is

not plugged into the wall outlet.

1. Remove the plastic  exible cap from the water valve.

2. Place the compression nut and ferrule (sleeve) onto the

end of the tubing as shown.

3. Insert the end of the copper tubing into the connection

as far as possible. While holding the tubing, tighten the

 tting.

10. TURN THE WATER ON AT THE SHUTOFF VALVE

Tighten any connections that leak.

11. PLUG IN THE REFRIGERATOR

Arrange the coil of tubing so that it does not vibrate

against the back of the refrigerator or against the wall.

Push the refrigerator back to the wall.

12. START THE ICEMAKER

Set the Ice Maker button to ON.

The icemaker will not begin to operate until it reaches

its operating temperature of 15°F (–9°C) or below. It

will then begin operation automatically if the Ice Maker

button is set to ON.

CAUTION: Check to see if leaks occur at the water line

connections.

¼” (6.35 mm) Tubing

Refrigerator

Connection

Tubing Clamp

¼” (6.35 mm)

Compression

Nut

Ferrule

(Sleeve)

Back of refrigerator

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 42 43

Comments to this Manuals

No comments

Kenmore 51737 Owner's Manual Page 33

Comments to this Manuals

Related products and manuals for Fridges Kenmore 51737