Kenmore Extra High-Efficiency Water Softener Owner's Manual download pdf (Page 16)

Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com

Salt

press for tonight

hold for immediate

Salt

Level

Low

LEVEL

SALT

ALARM

SALT

Set

Controller Features

Figure 21

Figure 22

EXTRA RECHARGE

Sometimes, a manually initiated recharge (regeneration)

may be desired, or needed. Two examples are:

= You have used more water than usual (guests visiting)

and you may run out of soft water before the next

automatic regeneration.

= You did not add salt to the softener before it ran out.

Add salt to the softener before regenerating.

You can start a regeneration immediately, or you can

set the controller to regenerate at the next preset

recharge time (2:00 AM, or as set).

RECHARGE NOW

Press the REGENERATION button and hold for 3 sec-

onds, until the words “RECHARGE”, “Serv” and “Fill”

begin to flash in the display. The softener enters the fill

cycle of regeneration immediately. This regeneration

will take about 2 hours to complete. Then, you will

have soft water again.

NOTE: If the “Clean Feature” is set ON, the normal

regeneration cycle is preceded by a cleaning

backwash and rinse. The words “CLEAN” and

“Bkwsh” or “Rinse” flash in the display, along

with the minutes of the clean cycle remaining.

RECHARGE TONIGHT

Press and release (do not hold) the REGENERATION

button. “RECHARGE TONIGHT” will begin flashing in

the display, and the softener will begin regeneration at

the next preset recharge time (2:00 AM, or as set). If

you decide to cancel the regeneration before it starts,

press and release the REGENERATION button once

more. “RECHARGE TONIGHT” will stop flashing in the

display.

3. Press the SET SALT LEVEL button as many times as

necessary to make the salt level bars in the display

(see Fig. 23) match the number on the decal. At

level 2 or below, the “Low Salt" indicator will flash.

4. If you want to turn the salt monitor off, press the SET

SALT LEVEL button past 8, until “OFF” shows in the

display next to the number 8.

SALT MONITOR SYSTEM

The water softener has a salt monitor indicator light to

remind you to add salt to the storage tank.

NOTE: You must set salt level each time salt is added

to the water softener.

NOTE: The salt monitor system estimates salt levels, and

accuracy will vary with different salts.

To set this monitor system:

1. Lift the salt lid and level the salt in the storage tank.

2. The yellow salt level decal, on the brinewell inside

the tank, has numbers from 0 to 8 (see Fig. 23).

Observe the highest number the leveled salt is at, or

closest to.

Figure 23

LEVEL

SALT

Salt

Level

Decal

Salt Level

Bars

Brinewell

Figure 24

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Comments to this Manuals

No comments

Kenmore Extra High-Efficiency Water Softener Owner's Manual Page 16

Comments to this Manuals

Related products and manuals for Water dispensers Kenmore Extra High-Efficiency Water Softener