Kenmore Vacuum Cleaner 116.21714 User Manual download pdf (Page 25)

8

Botón de

liberación

del tubo

Cepillo para

combinación

Botón de

liberación

del cepillo

MANGO

El Cepillo de combinacion puede ser

almacenado en el mango de la manguera,

colocandolo en el mango antes de

conectar el tubo telescopico. Desliza el

cepillo de combinación firmemente dentro

del mango.

Introduzca el tubo en el mango hasta que el

botón quede en posición. Asegúrese de que la

manguera no esté torcida.

Para retirar: Oprima el botón de liberación

rápida del mango para liberar el mango y

tire del mango hacia arriba.

Para Guardar: Para prevenir la presión de la

manguera mientras se guarda, desuna la

manguera del tubo de la aspiradora. Guarde

la manguera en una posición enrollada y floja

de tal manera que la tapa de la manguera no

se estire.

End Cap

End Cap

Belt Path

Brush Unit

25

TO CLEAN AGITATOR:

NOTE: In order to keep cleaning efficiency

high and to prevent damage to your

vacuum cleaner, the agitator must be

cleaned every time the belt is changed.

The agitator must also be cleaned

according to the following schedule:

Vacuum Cleaner Use Clean Agitator

HEAVY - every week

(used daily)

MODERATE - every month

(used 2-3 times/week)

LIGHT - every 2 months

(used 1 time/week)

IMPORTANT

Disconnect vacuum cleaner from electrical

outlet. Check and remove hair, string and

lint build-up frequently in the PowerMate

agitator and end cap areas.

Remove any dirt or debris in the belt

path area or in the brush roller area.

Carefully remove

any string or

debris located

on the agitator

or end caps.

AGITATOR ASSEMBLY

5. Rotate cover

back. Press cover

firmly until side

latches snap into

place.

6. Make sure there is no gap between the

cover and base and that the rear latches

are snapped in place.

7. Turn PowerMate upside down and replace

four (4) cover screws.

2. Place agitator

assembly into

PowerMate .

TO REPLACE BELT

NOTE: Use replacement belt STYLE CB-3,

see part number detail in REPLACEMENT

PARTS (page 5).

1. Install new

belt over

motor drive,

then over

belt path.

4. Line up front of cover and base. Rest

cover on front edge of base as shown.

Motor

Drive

Belt Path

End Cap

Agitator

3. NOTE: Be sure that the dirt sensor

board is positioned in slots and all wiring is

tucked back in place.

ENGLISH

Mango

Cepillo para

combinación

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments