Kenmore 81414 Owner's Manual download pdf (Page 20)

- 20 -

2. Place agitator

assembly back

into PowerMate

®

.

TO REPLACE BELT

1. Install new belt over motor shaft, then

over belt path.

NOTE: See REPLACEMENT PARTS for part

number and purchase details (page 5).

3. Line up front of cover and base. Rest

cover on front edge of base as shown.

4. Rotate cover back. Press cover ﬁrmly

until

side and rear latches snap into place.

NOTE: Make sure there is no gap between

the cover and base.

5. Turn PowerMate

®

upside down and replace

the four (4) screws that secure the cover

to the base.

End Cap

End Cap

Belt Path

Brush Unit

TO CLEAN AGITATOR:

NOTE: In order to keep cleaning eﬃciency

high and to prevent damage to your vacu-

um cleaner, the agitator must be cleaned

every time the belt is changed.

The agitator must also be cleaned accord-

ing to the following schedule:

Vacuum Cleaner Use Clean Agitator

HEAVY-

(used daily)

MODERATE-

(used 2-3 times/week)

LIGHT - every 2 months

(used 1 time/week)

IMPORTANT

Turn oﬀ and unplug vacuum cleaner from

electrical outlet. Check and remove hair,string

and lint build-up in the PowerMate

®

agitator

and end cap areas.

Remove any dirt or debris in the belt

patharea or in the brush unit area.

Carefully remove any string wound ontothe

agitator and end caps.

AGITATOR ASSEMBLY

every week

every month

Cover

Base

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 45 46

Comments to this Manuals

No comments