Kenmore 1.4 cu. ft. Trash Compactor - Black Owner's Manual download pdf (Page 8)

8. Determine whether you want the compactor cabinet or

drawer front flush with the kitchen cabinet face.

Using 2 - #8 - 18 x ⁵₁₆" mounting screws (provided in

conversion kit), attach the retaining brackets (provided in

conversion kit) to the compactor cabinet top as needed. See

“Accessories.”

NOTE: Installation hardware is not provided with full

cabinet models. See “Accessories” for ordering conversion

kit.

■ If the compactor cabinet face is to be flush with the

kitchen cabinet face, place retaining bracket mounting

screws through “1.”

■ If the compactor drawer front is to be flush with the

kitchen cabinet face, place retaining bracket mounting

screws through “3.”

■ If the compactor is to be midway between “1” and “3,”

place the retaining bracket mounting screws through

“2.”

9. Slowly lift the front slightly and roll compactor into the

kitchen cabinet opening.

10. Using 2 - #8 - 18 x ¹₂" mounting screws (provided in

conversion kit), fasten the retaining brackets (provided in

conversion kit) to the countertop with the mounting screws.

Countertop mounting

NOTE: If retaining brackets cannot be attached to the

underside of countertop, attach mounting clips (provided in

conversion kit) to retaining brackets. Fasten compactor to

kitchen cabinet face with mounting screws through the

mounting clips.

Cabinet-face mounting

11. Grasp sides of compactor drawer and place bottom of

drawer into tracks.

12. Lift at the handle so drawer will go over drawer stops.

13. Close drawer.

14. Check to see whether drawer opens freely. If the toe plate

rubs against floor, see “Adjusting the Toe Plate” for further

instructions.

Adjusting the Toe Plate

If the toe plate rubs the floor covering, the toe plate clearance

may be changed as follows:

1. Mark on each side of the toe plate the amount of toe plate

that rubs the floor covering.

2. Remove the drawer from the unit. See Step 3 in the

“Unpacking” section.

3. Use a ruler and a pencil or chalk to draw a line between the

marks on each side of toe plate.

4. Use scissors or utility knife to cut toe plate along line.

5. Replace drawer. If toe plate still rubs floor covering, repeat

steps 1-4.

A. Countertop

B. Retaining bracket (provided in conversion kit)

A. Countertop

B. Retaining bracket (provided in conversion

kit)

C. Mounting screw (provided in conversion kit)

A. Mounting clip (provided in conversion kit)

B. Kitchen cabinet

C. Retaining bracket (provided in conversion kit)

D. Mounting screw (provided in conversion kit)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Comments to this Manuals

No comments

Kenmore 1.4 cu. ft. Trash Compactor - Black Owner's Manual Page 8

Comments to this Manuals